Viking Access Systems f1 gate manual Viking Heater, Viking Lock Mode

Page 29

CONTROL BOARD SETUP

Viking Heater

The operator has an integrated heater that is thermostatically controlled. Activate this feature when the operator is used in application temperatures down to -20°F (-29°C).

To set the heater to turn on at the Close Limit:

1.Use the “Diagnose” button to scroll through the LCD Display to “HEATER CLS”

2.Press and hold the “Stop” button on the control board.

3.Press and release the “Diagnose” button to turn this feature ON and OFF.

To set the heater to turn on at the Open Limit:

1.Use the “Diagnose” button to scroll through the LCD Display to “HEATER OPN”

2.Perform steps 2-3 as described above.

HEATER CLS ON

HEATER OPN ON

NOTE: If the application requires the gate to be held open for any reason, set the HEATER ON for both limit positions.

!IMPORTANT: A POSITIVE STOP must be used on the gate at the limit position(s) the HEATER has been set for.

Viking Lock Mode

Turning this feature ON will secure the gate at the closed position, preventing unauthorized manual entry.

Use the LCD Display to activate this feature.

1.Use the “Diagnose” button to scroll through the LCD menu to “LOCK MOD”

2.Press and hold the “Stop” button on the control board.

3.Press and release the “Diagnose” button to turn this feature ON and OFF.

LOCK MOD ON

VIKING TECHNICAL SUPPORT 1.800.908.0884	2 7

Image 29

Contents Instructions Viking F-1 Swing Gate Operator Vehicular Gate Operator Revision F1NXMN10.D October Description Parts DiagramOperator References Control Board References Limit Setup ButtonsTable of Contents Important Installation Instructions Important Safety InformationImportant Safety Instructions Important Installation Instructions General Safety Precautions MaintenanceGlossary Install the gate operator only whenUL325 Gate Operator Classifications Secondary Entrapment Protection Photo Beam non-contact sensor InstallationWhen manual operation is required Edge Sensor contact sensor InstallationManual Release To resume normal operationManual Reset for the Audible Alarm Audible Alarm Reset Switch InstallationSingle Phase 50Hz / 60Hz SpecificationsAlternative Power 24VAC / VDC 60VA or Solar Locate Control ButtonsConcrete Pad Option Gate Operator InstallationRequired ADD-ON PART# VA-F1PS Post Mounting OptionTechnical Tips Operator and Arm Geometry Operator PositioningStep High Voltage Supply Option Electrical InstallationTips for proper ground installation Solar Supply Option Low Voltage Supply Option1a 1b Limits SetupAt the Limit Cam & Holder assembly Limits Setup Cable Requirements MASTER/SLAVE SetupTwo Wire Communication Required ADD-ON Choose option a or B Wireless Communication Options Timer Hold Open Timer Initial Settings ODS Obstruction Detection SensorAuto Open Power Failure Option Control Board SetupLast Open Power Failure Option Fail Safe ModeObstruction Sensor Primary Entrapment Protection When the Obstruction Sensor detects an obstruction it willODS Obstruction Detection Sensor Flashing OverloadUse the LCD Display to activate this feature Viking Lock ModeViking Heater To set the heater to turn on at the Close LimitThis page Left Blank Intentionally Re-Open Photo Beam vehicular Safety Accessory ConnectionsCOM + Check for proper operationOpen Only Radio Receiver TypicalOpen-Stop-Close Open Commands Anti-Tailgate, Open Commands & Guard StationGuard Station ATG Anti-TailgateViking Loop Rack Guidelines for Loop Installation Accessory ConnectionsMagnetic Lock Lock Solenoid Power for the LocksMagnetic Lock, Lock Solenoid Barrier Arm B-12 Synchronization Option Synchronization with B-12LED References TroubleshootingTroubleshooting LCD Display References LCD MSG MeaningTroubleshooting Error Messages Check SolutionsPower Connections Access Control ConnectionsRelays In General Appendix aGeneral Technical TIP Viking usesCommon Radio Receivers Connections Solar Applications Appendix CPanels Batteries & FuseViking Konnect Master/Slave Kit Secure and reliable Viking Konnect Diagnostic Tool On-site remoteViking Expansion Products OUR Continuous Commitment to Excellence Standard Features