Viking Access Systems f1 gate manual Troubleshooting

Page 39
3 7

TROUBLESHOOTING

LED References

Use the table below to identify the corresponding “TS Ref#” and refer to page 38-41 for

further troubleshooting.

 

Pg 41

#

LED

Status

Meaning

TS Ref#(s)

9

“C Loop”

OFF

Normal Condition.

 

 

 

SOLID

Control Board is receiving an input from a device connected to the

9, 10

 

 

 

C Loop terminal (pg 32, 42).

10

“Open”

OFF

Normal Condition.

 

 

 

SOLID

Control board is receiving an input from a device connected to any of

9, 10

 

 

 

the following input terminals: Exit, Fire, Strike or Open (pg 31, 42).

11

“STOP”

OFF

Normal Condition.

 

 

 

SOLID

Control Board is receiving an input from a device connected to the

9, 10

 

 

 

Stop terminal (pg 31, 42).

12

“Close”

OFF

Normal Condition.

 

 

 

SOLID

Control Board is receiving an input from a device connected to the

9, 10

 

 

 

Close terminal (pg 31, 42).

13

“Siren”

OFF

Normal Condition.

 

 

 

SOLID

Second consecutive obstruction has been detected. (pg 26).

11, 13, 1, 2

 

 

FLASHING

Batteries are critically low.

1, 2

14

“Aux. Pwr”

OFF

No voltage output on these terminals at the moment.

 

 

 

SOLID

There is 24VDC output on these terminals at the moment.

 

15

“Diagnose”

OFF

Normal Condition.

 

 

 

FLASHING

Errors have been detected; Check LCD Display for ERR messages (pg 40).

 

16

“Close Limit”

OFF

Gate is not at the close limit position.

 

 

 

SOLID

Gate is at the close limit position.

 

 

 

FLASHING

Indicates a problem with the limit switches or wires. (pg 20-21).

6

 

 

 

 

 

17

“Open Limit”

OFF

Gate is not at the open limit position.

 

 

 

SOLID

Gate is at the open limit position.

 

 

 

FLASHING

Indicates a problem with the limit switches or wires. (pg 20-21).

6

18

“ODS”

OFF

Normal Condition.

 

 

 

SOLID

Obstruction has been detected. (pg 26).

11, 13, 1, 2

 

 

FLASHING

Overload has been detected. (pg 26).

11, 13, 1, 2

19

“Timer”

OFF

The close timer is turned OFF or gate is not at the open limit if the timer is

 

 

 

 

turned ON. (pg 24).

 

 

 

SOLID

Gate is at Open Limit, Timer is turned ON and counting down to close. (pg

 

 

 

 

24).

 

 

 

FLASHING

Gate is at Open Limit, Timer is turned ON but is not timing out due to a

9, 10

 

 

 

conflicting command. (pg 24).

20

“AC VOLTAGE INPUT”

SOLID

Normal Condition.

 

 

 

OFF

Incoming power to Power Supply Panel Assembly is not sufficient.(pg 18).

1

21

“PROTECTION WORKING” SOLID

Normal Condition.

 

 

 

OFF

EMI Board is damaged and circuit is not protected . Replace EMI Board.

 

22

“AC VOLTAGE OUTPUT”

SOLID

Normal Condition.

 

 

 

OFF

There is no output voltage from the Power Supply Panel Assembly.

2

23

“AC POWER”

SOLID

Normal Condition for High Voltage installations.

 

 

 

OFF

High Voltage is not supplied to the Modular Power Box (pg 18).

1

VIKING TECHNICAL SUPPORT 1.800.908.0884

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Instructions Viking F-1 Swing Gate Operator Vehicular Gate Operator Revision F1NXMN10.D October Description Parts DiagramOperator References Control Board References Limit Setup ButtonsTable of Contents Important Safety Information Important Safety InstructionsImportant Installation Instructions Important Installation Instructions General Safety Precautions MaintenanceInstall the gate operator only when UL325 Gate Operator ClassificationsGlossary Secondary Entrapment Protection Photo Beam non-contact sensor InstallationTo resume normal operation Edge Sensor contact sensor InstallationWhen manual operation is required Manual ReleaseManual Reset for the Audible Alarm Audible Alarm Reset Switch InstallationLocate Control Buttons SpecificationsSingle Phase 50Hz / 60Hz Alternative Power 24VAC / VDC 60VA or SolarConcrete Pad Option Gate Operator InstallationRequired ADD-ON PART# VA-F1PS Post Mounting OptionTechnical Tips Operator and Arm Geometry Operator PositioningStep Electrical Installation Tips for proper ground installationHigh Voltage Supply Option Solar Supply Option Low Voltage Supply OptionLimits Setup At the Limit Cam & Holder assembly1a 1b Limits Setup MASTER/SLAVE Setup Two Wire CommunicationCable Requirements Required ADD-ON Choose option a or B Wireless Communication OptionsObstruction Detection Sensor Initial SettingsTimer Hold Open Timer ODSFail Safe Mode Control Board SetupAuto Open Power Failure Option Last Open Power Failure OptionFlashing Overload When the Obstruction Sensor detects an obstruction it willObstruction Sensor Primary Entrapment Protection ODS Obstruction Detection SensorTo set the heater to turn on at the Close Limit Viking Lock ModeUse the LCD Display to activate this feature Viking HeaterThis page Left Blank Intentionally Check for proper operation Accessory ConnectionsRe-Open Photo Beam vehicular Safety COM +Radio Receiver Typical Open-Stop-CloseOpen Only ATG Anti-Tailgate Anti-Tailgate, Open Commands & Guard StationOpen Commands Guard StationViking Loop Rack Guidelines for Loop Installation Accessory ConnectionsPower for the Locks Magnetic Lock, Lock SolenoidMagnetic Lock Lock Solenoid Barrier Arm B-12 Synchronization Option Synchronization with B-12LED References TroubleshootingTroubleshooting LCD Display References LCD MSG MeaningTroubleshooting Error Messages Check SolutionsPower Connections Access Control ConnectionsTechnical TIP Viking uses Appendix aRelays In General GeneralCommon Radio Receivers Connections Batteries & Fuse Appendix CSolar Applications PanelsViking Konnect Diagnostic Tool On-site remote Viking Expansion ProductsViking Konnect Master/Slave Kit Secure and reliable OUR Continuous Commitment to Excellence Standard Features

f1 gate specifications

Viking Access Systems has long been recognized as an industry leader in providing reliable, high-quality access control solutions, and their F1 Gate is a prominent example of this commitment to innovation and security. Designed to enhance the functionality and aesthetics of any residential or commercial property, the F1 Gate combines advanced technology with robust materials to ensure both durability and performance.

One of the standout features of the F1 Gate is its modular design. This system allows for customization according to the specific needs and preferences of the user. Whether for a driveway, garden, or secured entryway, the F1 Gate can be tailored in terms of size, style, and materials, providing versatility for any application. The gate can be crafted from high-grade steel or aluminum, ensuring long-lasting strength and resistance to weather conditions.

Incorporating cutting-edge automation technology, the F1 Gate operates smoothly and efficiently. It features a powerful motor that guarantees quick opening and closing, coupled with a silent operation to minimize disruption. Users can enjoy seamless access through a variety of control options, including remote controls, keypads, and smartphone applications, providing flexibility in managing entry points.

Safety is a top priority in the F1 Gate design. It comes equipped with advanced safety features such as obstacle detection and automatic reversing systems. These technologies ensure that the gate will halt or reverse if an obstruction is detected, protecting vehicles, pets, and pedestrians alike. Additionally, the gate can integrate with existing security systems, adding another layer of protection to properties.

The F1 Gate also boasts significant energy efficiency. With intelligent power management systems, it is designed to consume minimal energy, making it an eco-friendly choice for those conscious about their environmental impact without sacrificing functionality.

Aesthetically, Viking Access Systems understands the importance of curb appeal. The F1 Gate offers various finishes and colors, allowing users to select an option that complements their property’s architecture. The sleek design enhances the overall look while providing a secure barrier against unauthorized access.

In summary, the Viking Access Systems F1 Gate combines versatility, safety, technology, and aesthetic appeal. Its robust construction and advanced features make it an excellent choice for those seeking a reliable and stylish access solution, perfect for any environment and requirement. As technology continues to evolve, the F1 Gate stands at the forefront, embodying the future of secure access control.
Top Page Image Contents