Viking Access Systems f1 gate Anti-Tailgate, Open Commands & Guard Station, ATG Anti-Tailgate

Page 33

ACCESSORY CONNECTIONS

Anti-Tailgate, Open Commands & Guard Station

!TECHNICAL TIP: For more information regarding accessory connections and terminal functions, refer to “Appendix (A)” on pages 42-43.

Open Commands

“Exit”, “Fire” and “Strike” input terminals all provide an open command to the control board. Any device connected as shown will open the gate.

+	-	+
+	-	+		N.O.	COM
+	-	-			COM
+	-	-
		N.O.
		COM	N.O.
			N.O.
			COM

Guard Station

!All three buttons must be a Normally Open “N.O.” type of switch, and can share the same common “C” connection to “GND”.

“ATG” Anti-Tailgate

This input will stop the gate when the vehicle triggers the sensor, then closes the gate when the vehicle leaves the sensor, preventing unauthorized vehicles from entry.

+ -

COM

N.O.

VIKING TECHNICAL SUPPORT 1.800.908.0884	3 1

Image 33

Contents Instructions Viking F-1 Swing Gate Operator Vehicular Gate Operator Revision F1NXMN10.D October Description Parts DiagramOperator References Control Board References Limit Setup ButtonsTable of Contents Important Safety Information Important Safety InstructionsImportant Installation Instructions Important Installation Instructions General Safety Precautions MaintenanceInstall the gate operator only when UL325 Gate Operator ClassificationsGlossary Secondary Entrapment Protection Photo Beam non-contact sensor InstallationWhen manual operation is required Edge Sensor contact sensor InstallationManual Release To resume normal operationManual Reset for the Audible Alarm Audible Alarm Reset Switch InstallationSingle Phase 50Hz / 60Hz SpecificationsAlternative Power 24VAC / VDC 60VA or Solar Locate Control ButtonsConcrete Pad Option Gate Operator InstallationRequired ADD-ON PART# VA-F1PS Post Mounting OptionTechnical Tips Operator and Arm Geometry Operator PositioningStep Electrical Installation Tips for proper ground installationHigh Voltage Supply Option Solar Supply Option Low Voltage Supply OptionLimits Setup At the Limit Cam & Holder assembly1a 1b Limits Setup MASTER/SLAVE Setup Two Wire CommunicationCable Requirements Required ADD-ON Choose option a or B Wireless Communication OptionsTimer Hold Open Timer Initial SettingsODS Obstruction Detection SensorAuto Open Power Failure Option Control Board SetupLast Open Power Failure Option Fail Safe ModeObstruction Sensor Primary Entrapment Protection When the Obstruction Sensor detects an obstruction it willODS Obstruction Detection Sensor Flashing OverloadUse the LCD Display to activate this feature Viking Lock ModeViking Heater To set the heater to turn on at the Close Limit This page Left Blank Intentionally Re-Open Photo Beam vehicular Safety Accessory ConnectionsCOM + Check for proper operationRadio Receiver Typical Open-Stop-CloseOpen Only Open Commands Anti-Tailgate, Open Commands & Guard StationGuard Station ATG Anti-TailgateViking Loop Rack Guidelines for Loop Installation Accessory ConnectionsPower for the Locks Magnetic Lock, Lock SolenoidMagnetic Lock Lock Solenoid Barrier Arm B-12 Synchronization Option Synchronization with B-12LED References TroubleshootingTroubleshooting LCD Display References LCD MSG MeaningTroubleshooting Error Messages Check SolutionsPower Connections Access Control ConnectionsRelays In General Appendix aGeneral Technical TIP Viking usesCommon Radio Receivers Connections Solar Applications Appendix CPanels Batteries & FuseViking Konnect Diagnostic Tool On-site remote Viking Expansion ProductsViking Konnect Master/Slave Kit Secure and reliable OUR Continuous Commitment to Excellence Standard Features