LIMITS SETUP
STEP 1 Connect the “Limit Switch Harness” to the Control Board.
a.“OPEN RIGHT” Connector if the gate opens Right.
b.“OPEN LEFT” Connector if the gate opens Left.
1
1a 1b
STEP 2
At the “Limit Cam & Holder” assembly:
a.Loosen screws on both of the “Limit Switch Cams”.
b.With the Articulating Arm and “Clutch” installed, insure that the “Clutch Guide Pin” is seated into one of the four holes on the “Cam Holder”.
c.Move the gate manually to the desired closed limit position and adjust the
nearest Limit Switch Cam to actuate the corresponding limit switch.
d. Slight tighten the Limit Cam Screw.
e.Repeat Step 2c & 2d for the desired open limit position.
f.Run the 2 full cycles before confirming your limit settings. Adjust accordingly if required.
Tip: Referring to Step 2b. The “Cam Holder” contains four (4) Guide Pin holes to allow for proper positioning, if required, due to an alternative operator orientation.
Gate OPENS to the LEFT
Left Limit Switch | = | Closed Limit |
|
|
|
Right Limit Switch | = | Open Limit |
|
|
|
Gate OPENS to the RIGHT
Left Limit Switch | = | Open Limit |
|
|
|
Right Limit Switch | = | Closed Limit |
|
|
|
2 0 | VIKING TECHNICAL SUPPORT 1.800.908.0884 |
|
|