Viking Access Systems f1 gate manual Accessory Connections, Guidelines for Loop Installation

ACCESSORY CONNECTIONS

Guidelines for Loop Installation

1. Prevent sharp corners in the geometry of the loop sensor.

2. Install the appropriate number of turns for your loop geometry based on the loop perimeter. Use Table C (below) as a guide.

3. Use XLP (cross-linked-polyethylene) type of wire. This wire reduces the effects of moisture and other environmental events in altering the functionality of the vehicular loop detector.

4. Twist the lead wire at least 6 turns per foot.

5. Use BACKER-ROD to minimize damage to the loop detector wire prior to using the sealant.

6. Place the loop detector wire and adjust the sensitivity of the vehicular loop detector unit in a way to minimize the effects of the gate over the loop detector wire.

! IMPORTANT! Some of the following parameters may affect the proper functionality of the vehicular loop detector.

Consult the manufacturer of the vehicular loop detector and/or loop wire.

• Gate size

• Number of turns in the loop sensor wire

• Distance of the loop sensor wire to the gate at either at the open or close position

Table C - Recommended Number of Turns

Perimeter (ft.) Number of Turns

105

204

30-403

50-1002

	5'	Dimension “A” - 5’ for Single Gate
			6’ for Dual Gate
A	A	5'	5'
Outside	Center	Inside	Exit
Reopen		Reopen
	Loop		Loop
Loop		Loop
	5'	Make Even
		with Open Gate
		Gate in Open Position

VIKING TECHNICAL SUPPORT 1.800.908.0884 3 3