Lenovo 3000 V100 warranty Cpu Id

Solving computer problems

Code	Message	Description
02B0	Diskette drive A error	Drive A: or B: is present but fails the BIOS POST diskette
02B1	Diskette drive B error	tests. Check to see that the drive is defined with the proper
		diskette type in Setup and that the diskette drive is attached
		correctly.
02B2	Incorrect Drive A type -	Type of floppy drive A: not correctly identified in Setup.
	run SETUP
02B3	Incorrect Drive B type -	Type of floppy drive B: not correctly identified in Setup.
	run SETUP
02F0	CPU ID	CPU socket number for Multi-Processor error.
02F4*	EISA CMOS not writable	ServerBIOS2 test error: Cannot write to EISA CMOS.
02F5*	DMA Test Failed	ServerBIOS2 test error: Cannot write to extended DMA
		(Direct Memory Access) registers.
02F6*	Software NMI Failed	ServerBIOS2 test error: Cannot generate software NMI
		(Non-Maskable Interrupt).
02F7*	Fail - Safe Timer NMI	ServerBIOS2 test error: Fail-Safe Timer takes too long.
	Failed
N/A	Device Address Conflict	Address conflict for specified device.
N/A	Allocation Error for :	Run ISA or EISA Configuration Utility to resolve resource
	device	conflict for the specified device.
N/A*	Failing Bits: nnnn	The hex number nnnn is a map of the bits at the RAM
		address which failed the memory test. Each 1 (one) in the
		map indicates a failed bit. See errors 230, 231, or 232 above
		for offset address of the failure in System, Extended, or
		Shadow memory.
N/A	Invalid System	Problem with NVRAM (CMOS) data.
	Configuration Data
N/A	I/O device IRQ conflict	I/O device IRQ conflict error.
N/A	One or more I2O Block	There was not enough room in the IPL table to display all
	Storage Devices were	installed I2O block-storage devices.
	excluded from the Setup
	Boot menu
N/A	Operating system not	Verify the following: The hard disk drive is correctly
	found	installed. A startable diskette is in the diskette drive. If you
		still see the same error message, check the boot sequence
		using BIOS Utility.
N/A*	Parity Check 1 nnnn	Parity error found in the system bus. BIOS attempts to locate
		the address and display i on the screen. If it cannot locate the
		address, it displays ????. Parity is a method for checking
		errors in binary data. A parity error indicates that some data
		has been corrupted.

12Lenovo 3000 V100 Service and Troubleshooting Guide