Graco ISPC094CB owner manual ➊ Restr

7.1 Installing the Infant Restraint Without Base Using Vehicle Belt

You must carefully follow the instructions provided by your vehicle manufacturer, in addition to the information in this manual. Before proceeding be sure you have read and understood section 6, “Choosing an Appropriate Vehicle Seat Location” on pages 26-32.

Make sure vehicle is on level ground ➊ so that the level indicator, which is attached to the infant restraint, can

be used to properly recline the infant restraint.

If a front passenger seat is used (see air bag warning, page 8), slide the vehicle seat rearward as far as possible from the dashboard. If a rear seat is used, make sure the seat in front of it is moved forward enough and is upright enough to allow room for the infant restraint.

1. Place the infant restraint without base in a rear-facing position in a vehicle seat.

2. Thread the vehicle belt under both vehicle belt hooks:

Lap BeltLap/Shoulder

Belt

➊ Restr

33