JVC GY-DV5000 manual Zoom Lens Optional, S14 x 7.3B12U

2. CONTROLS, INDICATORS AND CONNECTORS

2-7 ZOOM Lens (Optional)

[S14 x 7.3B12U]

e w q

	RET	M
		A
	W	T
r	t	y u i o

!0!4

MACRO

!1 !2 !3

1 FOCUS ring Manual focus ring.

2ZOOM lever/ring

This is the manual zoom ring equipped with a zoom lever. To adjust the zoom manually, turn the zoom mode knob @ to position “M”.

3IRIS ring

Manual iris ring. To activate the auto iris feature, set the Iris Mode switch 7 to “A”.

4[VTR] Trigger button

To start/stop shooting.

5[RET] return video button

The return video signal from the VTR section can be monitored in the viewfinder only while this button is pushed.

*The playback picture can be viewed in the viewfinder during this operation.

6ZOOM servo control lever

To operate the servo zoom feature with this lever, set the ZOOM knob @ to “S”.

●Pressing the “W” section of this lever increases the angle of the lens for a wider shooting angle.

●Pressing the “T” section of this lever narrows the lens angle perspective for telephoto shots.

●Pushing harder changes the speed of the zoom.

7IRIS mode switch

A : Activates the auto iris feature.

M : Allows manual iris control.

8Momentary auto iris button

When the IRIS MODE switch 7is at “M”, pushing this button activates the Auto Iris Function while it is held down only.

9[S] IRIS speed adjusting control

For adjusting the iris operation speed.

MEMO:

If the speed becomes too fast, hunting may occur. To avoid the phenomena described above, perform adjustment again.

0FILTER thread

Protect the lens with a clear filter or UV filter by screwing the filter onto the thread inside the lens hood from the front. Other filters can be used for various effects.

CAUTION:

The filter thread section rotates, so pay attention when mounting a polarizing filter.

!ZOOM servo connector

Connect an optional zoom servo unit here.

@ZOOM mode knob

S : Servo zoom mode. Allows operation by the zoom servo control lever 6.

M : Manual zoom mode. Allows zoom control by the zoom lever/ring 2.

#BACK FOCUS ring/fixing screw

For back focus adjustment only. Secure with the screw knob after adjustment.

☞ See “Back Focus Adjustment” on page 47.

$Macro focusing ring (for close-up shooting)

By rotating this ring in the direction of the arrow, close-up shooting of very small objects becomes possible.

Normal focus adjustment and zooming are not available in the macro mode.

To shoot images in the macro mode, set the focus ring 1 to the infinite position (∞ ) and the zoom ring 2 to the maximum wide-angle position. To adjust the focus of the macro image, rotate this ring in the direction of the arrow until the object is focused.

CAUTION:

●The back-focus knob is located close to the macro ring, be careful not to mistake the back-focus knob for the macro ring.

●After the required operation, be sure to return the macro focusing ring to the normal position.

☞See “Attaching the Zoom Lens” on page 30.

☞See “Back Focus Adjustment” on page 47.

E-27