JVC GY-DV5000 manual Viewfinder Adjustment, External Monitor Adjustment, Colour video monitor

6. SETTING AND ADJUSTMENTS BEFORE SHOOTING

6-3 Viewfinder Adjustment

1. Adjust the position and angle of the viewfinder.

2.

Eyepiece

1.

2. Diopter adjustment

Rotate the eyepiece focusing ring until the viewfinder screen image is clearly visible.

3. Brightness and contrast adjustment

2. 1.

Eyepiece1. focusing ring

3. 3.

CONT BRIGHT

When the ambient brightness changes, etc., the brightness and contrast of the viewfinder screen can be adjusted with the BRIGHT and CONT controls.

MEMO:

The screen size of the viewfinder can be changed by selecting the desired size with the ASPECT RATIO item on the CAMERA OPERATION menu screen (4:3 or LETTER).

6-4 External Monitor Adjustment

PUSH

Colour video monitor

1.

LINE OUT

CH-1

Y/C OUT MONITOR OUT

3.~8. CH-2

2.

POWER VTR

ON OFF

■EBU type colour bars

White Yellow Cyan Green Magenta Red Blue Black

1 2 3 4 5 6 7 8

Display the camera built-in colour bar signal on the video monitor and adjust the colours, contrast and brightness.

1. Connect a colour video monitor to the MONITOR OUT connector of the GY-DV5000.

2. Set the COLOR BARS/CAMERA/AUTO KNEE switch to BARS to output the colour bar signal (EBU type colour bars).

3. Set the monitor’s BLUE CHECK function to ON while the colour bars are being displayed so that the screen turns entirely blue and the colour bars become blue stripes.

4. Adjust the CHROMA control of the monitor so that there is no difference in brightness between the colour bars 1 and 7.

5. With the BLUE CHECK function ON, adjust the PHASE control of the monitor so that there is no difference in brightness between the colour bars 3 and 5.

6. If the phase control adjustment above causes a difference in brightness between the colour bars 1 and 7, start again from the CHROMA control adjustment in step 4.

7. Set the monitor’s BLUE CHECK function to OFF to switch the monitor back to the standard screen (R, G and B will all appear).

E-46