JVC GY-DV5000 Reproducing Time Codes, Set the TC Gene switch inside the cover on the side to

10. TIME CODE OPERATION

10-3 Recording Time Codes in Continuation of Time Codes Recorded on Tape

The GY-DV5000 also incorporates a time code reader. Therefore, when the unit enters record mode from record-standby mode, it can read the time code data recorded on the tape and record time codes in continuation of the existing data. The recorded user’s bit data are identical to the user’s bit data recorded on tape.

●However, approximately ±1-frame variations may occur in scene accuracy.

To enable this function, set the time code related switches as follows before starting recording.

Setting

■ Set the TC GENE switch inside the cover on the side to

REGEN.

								LCD	BRIGHT	DISPLAY
				OPEN
							MONITOR
							SELECT			COUNTER
							CH-1	FRONT
							MIX			TC
							CH-2	REAR		UB
				CH-1	AUDIO	CH-2		CH-1	CH-2
					LEVEL			AUDIO INPUT
		LCD BRIGHT		DISPLAY		AUDIO INPUT		AUDIO SELECT		TC GENE.
						FRONT	REAR	CH-1	CH-2
	AUDIO						LINE		AUTO	REGEN FREE
	LEVEL			PULL			+48V	MANUAL		PRST
		FRONT		OPEN
CH-1	CH-2	REAR
		CH-1	CH-2
		AUDIO INPUT
		AUDIO SELECT
		CH-1	CH-2
		AUTO
		MANUAL

TC GENE switch

10-4 Reproducing Time Codes

The GY-DV5000 incorporates a time code reader. During playback, the time code or user’s bit data recorded on the tape is displayed on the LCD monitor or in the viewfinder. (Status screen)

Playback time code indication

00:00:00:00

Setting

☞See “Displaying Time Code” on page 64.

CAUTION:

A time code with a duration of more than 2 hours may not be displayed correctly by DV components for general consumer use, as some of these lack the capability to display longer time codes.

	12.2V
PLAY	01/02/03 01:23:45
	Status screen

E-66