Power Supply, AC Operation, Camera

4. POWER SUPPLY

The GY-DV5000 is operable with AC power supply or battery pack.

4-1 AC Operation

Use the JVC AA-P250 AC power adapter (max. rated output 12.5 V DC, 3.5 A) as the AC power supply.

AA-P250

DC cable

AC power adaptor

PHONES

REAR AUDIO IN

TALLY

DC IN

DC OUT

Do not use any power source with large fluctuations in the power source voltage, power sources generating noise, such as ripples or power sources with lower voltage.

1. After making sure that the power switches of the GY-DV5000 and of the AA-P250 are set to OFF, connect the DC cable from the AA-P250 to the DC IN connector of the GY-DV5000 as shown in the illustration.

2. Set the CHARGE/CAMERA switch of the AA-P250 to

CAMERA.

3. Press the POWER switch of the GY-DV5000 to ON. Power is supplied to the VTR section and the camera.

* For details, read the instruction manual of the AA-P250.

MEMO:

Do not remove or connect the DC cable while recording is being performed.

4-2 Battery Pack Operation (Optional)

The GY-DV5000 can be operated with the following battery packs.

■Flat shape type battery pack

■Anton-Bauer battery pack

● Propack 13/14 Series	
● Trimpack 13/14 Series	
● Trimpack 13/14 Series	
● Magnum 13/14 Series	
● Compack 13/14 Series	
● Compack 13/14 Series

*An Anton-Bauer battery pack cannot be connected directly to the GY-DV5000. It is necessary to mount the optional battery holder.

Battery holder: Anton-Bauer QRQ27

For details on how to mount the battery holder, see page 35.

●When the DC cable is connected to the DC IN connector, the power supply from the battery pack is interrupted and the power starts to be supplied through the DC IN connector.

●Do not connect or disconnect the DC cable while operating with a battery pack.

The following symptoms may occur if the DC cable is connected or disconnected while operating with a battery pack.

•The power is cut off for a moment when the DC cable is disconnected.

•Noise to the video and audio signals occurs. Audio signal are muted.

●When operation is continued with DC input after the battery pack capacity has been used up, set the POWER switch to OFF after the DC power is applied. Then switch ON again.

●If the GY-DV5000 is left with the battery pack attached, a small amount of power is consumed even if the POWER switch on the GY-DV5000 is set to OFF. Remove the battery pack when the GY-DV5000 is not going to be used.

E-33