JVC GY-DV5000 manual Cassette Loading and Unloading, Loading the Cassette, REC Save, Vtr

5. PREPARATIONS

5-2 Cassette Loading and Unloading

OPEN knob

Cassette cover Cassette insertion slot

Cassette cover

●A cassette cannot be loaded or unloaded while the GY-DV5000 is in POWER OFF mode.

●Use a standard DV videocassette or a MiniDV videocassette.

●Press at the center portion of the cassette back and insert the cassette tape straight into the slot.

REC/SAVE switch

Standard DV videocassette

Cassette insertion slot

Guide

MiniDV videocassette

Guide

After the cassette cover is closed, it takes about 10 seconds before the unit can start recording or before it enters the STOP mode.

Loading the Cassette

1. Set the POWER switch to ON.

2. Slide the OPEN knob to the side to open the cassette cover.

3. Insert a videocassette into the cassette slot after removing the tape slack.

■Insert a standard DV videocassette along the cassette insertion slot by pressing at the center portion of the cassette back.

■Insert a MiniDV videocassette between the left and right side guides on the cassette insertion slot.

The tape window should face outward and the cassette back switch should be up. Press on the center of the back of the videocassette and ensure that it is fully inserted.

4. After the tape is completely loaded, slowly close the cassette cover by pushing it in all the way.

■The status when the tape is loaded differs with the mode of the GY-DV5000 (Camera mode or VTR mode) and the condition of the REC/SAVE switch on the back of the cassette as show below.

	REC/SAVE Switch
	REC	SAVE
Camera	Record-standby mode	STOP mode . REC
		INHIBIT is displayed on
		the LCD monitor and in
		the viewfinder.
VTR	STOP mode

Recording can be started by pressing the VTR trigger button from the record-standby mode.

CAUTION:

Do not attempt to push the cassette all the way in while the cassette is being pulled in automatically. This could result in damage.

E-38