Panasonic WV-NS202A operating instructions Setting example of the router

Setting example of the router

This camera transmits MPEG-4 images using UDP protocol.

To display MPEG-4 images using a router, it is necessary to configure the settings (UDP port setup) of both the camera and the router as below.

Step 1

Configure "MPEG-4 setup" of the camera as follows.

qTransmission type: Unicast port (MANUAL) w Unicast port1 (Image): 32004

e Unicast port2 (Audio): 33004

Step 2

Configure the router q to which the camera is connected as follows.

Address mapping table

Group	LAN IP address		LAN port			WAN IP address		Protocol
		192.168.0.10	TCP port: 80		<--->	WAN IP address of the router		HTTP (TCP port: 80)
Camera		192.168.0.10	UDP port: 32004		<--->	WAN IP address of the router		UDP port: 32004
		192.168.0.10	UDP port: 33004		<--->	WAN IP address of the router		UDP port: 33004
Step 3
Configure the router w to which the PC is connected as follows.
Address mapping table*
Group		WAN IP address			Protocol		LAN IP address	LAN port
	WAN IP address of the router			UDP port: 33004		<--->	192.168.0.101	UDP port: 33004
PC
	WAN IP address of the router			UDP port: 32004		<--->	192.168.0.101	UDP port: 32004
IP address: 192.168.0.10
	LOCK	OPEN						PC
					Internet
			Router q				Router w

IP address: 192.168.0.101

* The address mapping table is the example for when using a typical router.

Depending on the manufacturer of the router, it may be described as "static IP masquerade".

89