Preset memories
This unit enables up to 100 settings for the camera direction (panning and tilting), zoom, focus and iris to be registered in its preset memories, and called.
However, the number of settings that can be registered and called depends on the type of wireless remote control or controller that is used for operation.
The status as to whether the manual settings or auto settings are applicable is not registered for the focus and iris. The current focus and iris values are registered.
The focus and iris values can be recalled only when the manual settings are applicable.
When performing the operations using the
accessory wireless remote control
Twelve settings (preset No.1 to No.12) can be registered and called using the wireless remote control.
The [1] to [12] buttons correspond to the unit’s preset memories No.1 to No.12.
Registering the settings in the preset memories
1 Display the picture to be shot on the monitor.
Operate the pan, tilt or zoom buttons to determine the camera angle.
Adjust the focus and iris if they need to be adjusted.
2 While holding down the [PRESET] button,
press the button corresponding to the preset memory number.
If a preset memory number with an already registered setting has been selected, the existing setting will be erased and replaced with the new one.
When performing the operations
using the controller
When the
Up to 50 settings can be registered and called.
The [1] to [50] buttons of [TRACING/PRESET MEMORY] correspond to the unit’s preset memories No.1 to No.50.
Registering the settings in the preset memories
1 Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2 Set to the memory recording mode.
Press the [M.LOCK] button to turn off its lamp.
3 Display the picture to be shot on the monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to determine the camera angle.
Adjust the focus and iris if they need to be adjusted.
Calling the settings of the preset memories
1 Press the button in which the preset memory setting has been registered.
4 Hold down the [MEMORY] button.
The buttons among the [1] to [50] buttons of [TRACING/PRESET MEMORY] in which settings can be registered now start blinking in sequence.
Preset memory settings cannot be registered in buttons whose lamps are off (since they contain tracing memory settings).
5 With the [MEMORY] button still held down, press the button of the preset memory number in which the setting is to be registered.
29