Setting/releasing the limiters
Basic limiter operations
1 Press the [MENU] button.
Tap the button (rather than pressing it). When it is pressed for two seconds, a menu will appear.
If this happens, press the [MENU] button again for two seconds to clear the menu.
Then start again from step 1.
2 Press the [], [], [] or [] button for two seconds while holding down the [PRESET] button.
The limiter for the upper limit, lower limit, left limit or right limit is set (or released) using these direction buttons, respectively.
The tally lamp will blink at this time.
When a limiter is set, it blinks once; when a limiter is released, it blinks twice.
If any other button was operated between steps 1 and 2, start again from step 1.
Setting the limiters
The limiter positions can be set by following the steps below. When the position is set, the tally lamp blinks once.
1 Press one of the [CAM1] to [CAM4] buttons to select the unit.
Setting the upper limit position of the movement range
Press the [] or [] button of the wireless remote control to turn the unit as far as the position which will serve as the upper limit.
Next, perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Setting the lower limit position of the movement range
Press the [] or [] button of the wireless remote control to turn the unit as far as the position which will serve as the lower limit.
Next, perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Setting the
Press the [] or [] button of the wireless remote control to turn the unit as far as the position which will serve as the
Next, perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Setting the
Press the [] or [] button of the wireless remote control to turn the unit as far as the position which will serve as the
Next, perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Releasing the limiters
The limiter positions that are set can be released by following the steps below.
When the position is released, the tally lamp blinks twice.
1 Press one of the [CAM1] to [CAM4] buttons to select the unit.
2 Release the limiters by taking the steps below.
Releasing the upper limit position of the movement range
Perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Releasing the lower limit position of the movement range
Perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Releasing the
Perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Releasing the
Perform the steps in “Basic limiter operations”, and press the [] button for two seconds while holding down the [PRESET] button.
Resetting the limiters
To reset the limiters, the currently established settings must be released.
The limiter positions that are set can be reset by following the steps below.
1 Release the settings of the limiter positions to be reset by following the steps in “Releasing the limiters”.
2 Set the limiter positions by following the steps in “Setting the limiters”.
54