Setting the menu items
Genlock/color bar setting menu
The same settings established on the genlock/color bar setting menu are common to all the shooting modes (halogen light mode, fluorescent light mode, daylight mode and user mode).
(When a setting in one mode is changed, the same setting is established in the other modes.)
| G/L, Setup Set |
| |
1 | ±0 | ||
2 | Coarse | 90deg | |
3 | Fine | ±0 | |
4 | On |
1Horizontal phase adjustment [H Phase:
(Factory setting: ±0)
Using this item, the horizontal phase during genlock can be adjusted.
2Color phase coarse adjustment
[SC Coarse: 0deg, 45deg, 90deg, 135deg, 180deg, 225deg, 270deg, 315deg]
(Factory setting: 90deg)
Using this item, the color phase during genlock can be adjusted coarsely. This setting takes effect only when VBS or Y/C signals are output as the video signals.
3Color phase fine adjustment [SC Fine: –127 to +127]
(Factory setting: ±0)
Using this item, the color phase during genlock can be adjusted finely. This setting takes effect only when VBS or Y/C signals are output as the video signals.
4Setup level selection
[Setup Level: Off (0 IRE), On (7.5 IRE)]
(Factory setting: On)
Using this item, the setup level can be selected.
5Return to the previous menu (menu for selecting the shooting mode) [Return]
Sharpness setting menu (user mode only)
The sharpness setting menu is provided in the user mode only.
| Sharpness(DTL) Set |
|
1 | On | |
2 | 2 | |
3 | 4 | |
4 | 0 |
1Detail ON/OFF selection [Detail: On, Off]
Using this item, ON or OFF is selected for detail compensation.
When “On” is selected, the amount of the detail compensation can be adjusted using the “Total Detail Level” and “V Detail Level” menu items.
2Total detail level selection [Total Detail Level: 0 to 14, ---]
(Factory setting: 7)
Using this item, the amount of the edge enhancement in the horizontal and vertical directions is selected.
When “Off” is selected as the detail ON/OFF selection setting,
3Vertical detail level selection [V Detail Level: –7 to +7, ---]
(Factory setting: ±0)
Using this item, the amount of the edge enhancement in the vertical direction is selected.
When “Off” is selected as the detail ON/OFF selection setting,
4Noise suppression [Noise Suppress: 0 to 7]
(Factory setting: 0)
Using this item, the amount of screen noise generated by the detail can be reduced. The higher the value selected, the greater the reduction of the noise. However, if too high a value is selected, the sharpness of detailed subjects will be reduced.
5Return to the previous menu (menu for selecting the shooting mode) [Return]
49