Cisco Systems 4300 manual Option Description, Current Channel Area, Streaming Setup Area

Chapter 3 Configuring and Managing the IP Camera

Feature Setup Windows

If you change any options in this window, you must click the Save Settings button to save the changes. If you do not click this button, changes are not retained when you exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.

Table 3-2describes the options in the Streaming Settings window.

Table 3-2 Streaming Settings Window Options

Option	Description
Current Channel Area
Channel	Choose the video stream (Channel 1 or Channel 2) to which the
	configuration settings in the Streaming Settings window apply. Channel 1 is
	the primary stream and Channel 2 is the secondary stream.
Enable Channel	Check this check box to cause the IP camera to send audio/video data on the
	selected stream.
Channel Name	Name of the video stream.
	The name can contain up to 16 characters, which can be letters, numbers, and
	special characters, but no spaces. Special characters are: ! % ( ) + , - : = @ _ ~
Streaming Setup Area

Note These options apply to the primary stream only.

		Enable SRTP	Check this check box to enable Secure Real-time Transport Protocol (SRTP),
			which provides encryption for the audio/video stream from the IP camera.
		RTSP Port	Transmission Control Protocol (TCP) port on which the IP camera receives
			Real-Time Streaming Protocol (RTSP) commands. You must configure this
			port if you want to allow third-party devices or software to access video
			streams from the IP camera.
			RTSP is a standard for connecting a client to control streaming data over the
			web.
			Valid values are 554 and 1024 through 65535. The default port is 554.
		Video Source Port	Universal Datagram Protocol (UDP) port on which the IP camera transmits
			Video Real-Time Transport Protocol (RTP) data.
			Valid values are even numbers 1024 through 65534. The default port is 1024.
		Audio Source Port	UDP port on which the IP camera transmits audio RTP data
			Valid values even numbers 1024 through 65534. The default value is 1026.
		Max RTP Packet Size	Maximum number of bytes per data packets that are sent in each RTP
			request.
			Configure a lower number if you are streaming video to a cell phone that
			requires smaller data packets.
			Valid values are 400 through 1400. The default value is 1400.
		Enable Multicast	Check this check box to send video and audio data as a multicast stream.
			When multicast is enabled, the IP camera sends video and audio to the
			multicast addresses that you designate. Multicast enables several devices to
			receive the video signal from the IP camera simultaneously.
		Multicast Address	Enter the multicast IP address on which the IP camera sends a multicast
			audio/video stream.
	Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
3-4			OL-19609-04