Cisco Systems 4300 manual QoS Settings Window, IP Filter Area, Filter Entries Area

Chapter 3 Configuring and Managing the IP Camera

Network Setup Windows

To display the IP Filtering window, access the configuration windows as described in the “Performing the Initial Setup of the IP Camera” section on page 2-5, click Network Setup, then click IP Filtering.

If you change any options in this window, you must click the Save Settings button to save the changes. If you do not click this button, changes are not retained when you exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.

Table 3-15describes the options in the IP Filter Settings window.

Table 3-15 IP Filter Settings Window Options

Option Description

IP Filter Area

Enable IP Filtering

Check this check box to cause the IP camera to allow or deny access to IP addresses as configured in the IP Filtering window.

Filter Entries Area

#	Display only. Filter number.
Action	Choose an action for the corresponding IP address or address range:
	• Deny—IP address or address range cannot access the IP camera
	• Allow—IP address or address range can access the IP camera
IP Address/Bit Mask	Enter the IP address and bit mask to which the corresponding action applies.
	Make these entries in Classless Inter-Domain Routing (CIDR) notation.
	CIDR is defined in RFC 4632.

QoS Settings Window

The QoS Settings window provides options for configuring quality of service (QoS) settings for audio/video streams.

To display the QoS Settings window, access the configuration windows as described in the “Performing the Initial Setup of the IP Camera” section on page 2-5, click Network Setup, then click IP Filtering.

If you change any options in this window, you must click the Save Settings button to save the changes. If you do not click this button, changes are not retained when you exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.

Table 3-16describes the options in the QoS Settings window.

Table 3-16 QoS Settings Window Options

Option

Description

Class of Service (CoS) Area

	Enable CoS for Video	Check this check box to enable class of service (CoS) control for video
	Streaming	streams.
		If you enable this option, the IP camera specifies a VLAN tag that appends
		to an Ethernet MAC frame for video streaming data.
	Video Priority	Value from 0 (lowest priority) through 7 (highest priority) that specifies the
		CoS priority value for steaming video data.
	Video VLAN ID	Enter the ID of the video VLAN to which CoS packets are directed.
		Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
OL-19609-04			3-25