Cisco Systems 4300 manual Pan/tilt speed controls, Motion detection

Chapter 4 Viewing Live Video

Table 4-1	Camera Video/Control Window Controls (continued)
Control		Description
Right Arrow toggle		Click the Right Arrow to display the pan/tilt speed controls. The button
button		changes to the Left Arrow button.
		Click the Left Arrow button to hide the pan/tilt speed controls. The button
		changes to the Right Arrow button.
Left Arrow toggle
button

Pan/tilt speed controls

Note These controls appear when you click the Right Arrow in the Pan/Tilt area.

Pan Speed slider	To control the relative speed of panning for the IP camera, drag the slider, or
	enter a value from 1 through 100 and press the Enter key. A higher value
	increases pan speed and a lower value decreases pan speed.
	The default value is 50.
Tilt Speed slider	To control the relative speed of tilting for the IP camera, drag the slider, or
	enter a value from 1 through 100 and press the Enter key. A higher value
	increases tilt speed and a lower value decreases tilt speed.
	The default value is 50.
Restore button	Click this button to set the pan speed and tilt speed to their default values.
Motion detection

Note If you configure MJPEG for video control, the motion detection functions are available only if you disable the primary video stream (channel 1). For information about enabling and disabling video streams, see the “Streaming Settings Window” section on page 3-3.

Up Arrow toggle button

Down Arrow toggle button

Click the Up Arrow to display the motion detection controls. The button changes to the Down Arrow button.

Click the Down Arrow button to hide the motion detection controls. The button changes to the Up Arrow button.

Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide

4-6 OL-19609-04