Cisco Systems 4300 manual Patrol Sequence Area

Chapter 3 Configuring and Managing the IP Camera

Feature Setup Windows

To display the Patrol Sequence window, access the configuration windows as described in the “Performing the Initial Setup of the IP Camera” section on page 2-5, click Feature Setup, then click Patrol Sequence.

If you change any options in this window, you must click the Save Settings button to save the change. If you do not click this button, changes are not retained when you exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.

Table 3-8describes the option in the Patrol Sequence window.

Table 3-8 Patrol Sequence Window Options

Option	Description
Patrol Sequence Area
Dwell Time	Choose the length of time in seconds that the camera remains in each preset
	position when a patrol sequence executes.
Available list	Configure the order in which the IP camera executes up to 8 steps in a patrol
Selected list	sequence. The Available list displays preset positions that you can use in the
	patrol sequence. You define these preset positions in the Camera
	Video/Control window. The Selected list displays the steps in the patrol
	sequence.
	When the patrol sequence executes, the IP camera goes to the first preset
	position in the Selected list, then moves through each position in the list in
	order. It remains in each position for the time that is defined in the Time
	Delay field. It stops at the last position in the list.
	To move preset positions between the Available list and the Selected list, use
	the following buttons. Buttons become highlighted when they are available.
		—Move the selected preset position or positions from the Available
		list to the Selected list. To select a preset position, click it to
		highlight it. To select more than one preset positions, Ctrl-click
		each one.
		—Move the selected preset position or positions from the Selected
		list to the Available list. To select a preset position, click it to
		highlight it. To select more than one preset positions, Ctrl-click
		each one.
		—Move all preset positions from the Available list to the Selected
		list.
		—Move all preset positions from the Selected list to the Available
		list.
	To configure the order of steps in the Selected list, use the following buttons.
	Buttons become highlighted when they are available. To select a preset
	position, click it to highlight it.
		—Move the selected preset position to the top of the list.
		—Move the selected preset position up one position.
		—Move the selected preset position down one position.
		—Move the selected preset position to the bottom of the list.

	Cisco Video Surveillance 4300 and 4500 High-Definition IP Cameras User Guide
OL-19609-04		3-15