4XEM IPCAMWFD manual Viewing System Log, Viewing System Parameters, Factory Default

Page 57

Viewing System Log

Click on the link on the configuration page to view the system log file. The content of the file provides useful information about configuration and connections after system boot-up.

Viewing System Parameters

Click on this link on the configuration page to view the entire system’s parameter set. The content is the same as those in CONFIG.INI.

Factory Default

“Factory default”

Click on this link on the configuration page to restore factory default settings. Any changes made so far will be lost and the system will be reset to the initial factory settings. After clicking on the “Restore” button and make confirmation, the system will restart and require the installer program to set up the network again.

“Calibrate”

Recalibrate the home position to the default center to recover the tolerance caused by some external forces. This function is the same as the “Center” button on the Remote Controller. Please note that there is no confirming message box after clicking on the “Calibrate” button, the Network Camera will calibrate immediately.

- 53 -

Image 57

Contents Page Page Before You Use This Product Package Contents Table of Contents Appendix Smtp FTPPage Ethernet Connection Hardware InstallationMount the Camera Page Page Page Software Installation Page Page Page Installing Plug-in Initial Access to the Network CameraAdd Password to Prevent Unauthorized Access Check Network SettingsAuthentication How to UseMain Screen with Camera View Primary User’s CapabilitiesCamera view ConfigurationBoth Client SettingsPage Fine-tuning for Best Performance Administrator’s CapabilitiesSomewhere Between Real-time and Clear Images For Best Real-time Video ImagesOnly Quality Images Will Do Select for Motion Jpeg Opening Accounts for New Users Protect Network Camera by PasswordsProduct Demo for E-business Large-scale Service Demo on Multiple Sites Mid-scale ServiceIf the web space has FTP service Build a Multimedia Web Attraction SitePage If the web space has no FTP service Image URL Build a Security Application Send Snapshots When Motion is DetectedPage Definitions in Configuration System Parameters User Group Administration Page Edit User General Network SettingsStreaming Ddns & UPnP Page Smtp Mail & FTPPage Page Video Codec Parameters Page Contrast Hue Saturation Image SettingsCamera Settings Audio Page Motion Detection Application Setup Weekly ScheduleEvent Operation Sequential Operation FTP Naming rule of snapshot filePage Factory Default Viewing System LogViewing System Parameters Appendix TroubleshootingFrequently Asked Questions Page Page URL commands of Network Camera OverviewStyle convention General CGI URL syntax and parameters Get server parameter valuesMethod GET/POST Parameter pair Set server parameter valuesParameter pair Skip to invoke default server WirelessNetwork Camera With Pan/Tilt/ZoomAvailable parameters on the server Yyyy/mm/ddNTP Group Security 192.168.0.99255.255.255.0 Dns1 IP address Primary DNS server 5002 5003120 384000For Ntsc only 8000 Save Directly save the adjust image Parameters Group CCD Ntsc & Cmos Script.vssx Application page CGI command Sun Dihigh Query status of the digital input Drive the digital outputQuery status of the digital output Capture single snapshot Edit Account managementPrivilege=dido&privilege=listen System logsSystem Information Configuration filePage Preset Locations Networking Technical Specifications