4XEM IPCAMWFD manual Check Network Settings, Add Password to Prevent Unauthorized Access

Page 18

Check Network Settings

The Network Camera can be connected either before or immediately after software installation onto the Local Area Network. The Administrator should complete the network settings on the configuration page, including the correct subnet mask and IP address of gateway and DNS. Ask your network administrator or Internet service provider for the detail information. By default the Network Camera requires the Administrator to run installation every time it reboots. If the network settings are to remain unchanged, disable the Install option. Refer to “Network settings” on the System Configuration page for details. If any setting is entered incorrectly and cannot proceed to setting up the Network Camera, restore the factory settings following the steps in the “Troubleshooting” chapter of the Appendix.

Add Password to Prevent Unauthorized Access

The default Administrator’s password is blank and the Network Camera initially will not ask for any password. The Administrator should immediately implement a new password as a matter of prudent security practice. Once the Administrator’s password is saved, the Network Camera will ask for the user’s name and password before each access. The Administrator can set up a maximum of twenty (20) user accounts. Each user can access the Network Camera except to perform system configuration. Some critical functions are exclusive for the Administrator, such as system configuration, user administration, and software upgrades. The user name for the Administrator is permanently assigned as “root”. Once the password is changed, the browser will display an authentication window to ask for the new password. Once

the password is set, there is no provision to recover the Administrator’s password. The only option is to restore to the original factory default settings.

- 14 -

Image 18

Contents Page Page Before You Use This Product Package Contents Table of Contents Smtp FTP AppendixPage Hardware Installation Ethernet ConnectionMount the Camera Page Page Page Software Installation Page Page Page Initial Access to the Network Camera Installing Plug-inCheck Network Settings Add Password to Prevent Unauthorized AccessHow to Use AuthenticationPrimary User’s Capabilities Main Screen with Camera ViewConfiguration Camera viewClient Settings BothPage Administrator’s Capabilities Fine-tuning for Best PerformanceSomewhere Between Real-time and Clear Images For Best Real-time Video ImagesOnly Quality Images Will Do Select for Motion Jpeg Protect Network Camera by Passwords Opening Accounts for New UsersIf the web space has FTP service Demo on Multiple Sites Mid-scale ServiceProduct Demo for E-business Large-scale Service Build a Multimedia Web Attraction SitePage If the web space has no FTP service Image URL Send Snapshots When Motion is Detected Build a Security ApplicationPage Definitions in Configuration System Parameters User Group Administration Page Edit User Network Settings GeneralStreaming Ddns & UPnP Page Mail & FTP SmtpPage Page Video Codec Parameters Page Image Settings Contrast Hue SaturationCamera Settings Audio Page Motion Detection Application Setup Weekly ScheduleEvent Operation Sequential Operation Naming rule of snapshot file FTPPage Factory Default Viewing System LogViewing System Parameters Troubleshooting AppendixFrequently Asked Questions Page Page URL commands of Network Camera OverviewStyle convention General CGI URL syntax and parameters Get server parameter valuesMethod GET/POST Set server parameter values Parameter pairParameter pair Available parameters on the server WirelessNetwork Camera With Pan/Tilt/ZoomSkip to invoke default server Yyyy/mm/ddNTP Group Security 192.168.0.99255.255.255.0 Dns1 IP address Primary DNS server 5003 5002120 384000For Ntsc only 8000 Save Directly save the adjust image Parameters Group CCD Ntsc & Cmos Script.vssx Application page CGI command Sun Dihigh Drive the digital output Query status of the digital inputQuery status of the digital output Capture single snapshot Account management EditSystem logs Privilege=dido&privilege=listenConfiguration file System InformationPage Preset Locations Technical Specifications Networking