Micon IP-220E manual Snmp Setting, Using Snmp to update network ports

Page 28

Chapter 4: iGuardware

Click “Modify…” to modify the entered Email Address

Click “Delete” to remove an email address from the notification list.

4.2.2.5 SNMP Setting

Host Name:	Provide a Name to identify this device.
HTTP Port:	Enter the HTTP port assigned for iCAMView.
Location:	Provide a location for SNMP manager to track device.
Manager:	Enter a manager’s name for identification.

“Using SNMP to update network ports”

Check this box if you want iMultiView to automatically update the HTTP port as set in iCAMView Web (Basic settingsÂNetworkÂPort NumberÂHttp port number) or iCAMView Utility (IP configurationÂAdvancedÂManagement Protocol)

27

Image 28

Contents IGuard Contents Page Features IntroductionPackage Contents IGuard IP-220E Hardware Light color Condition descriptionHardware Installation Installation Procedure StepInstalling iGuardware IGuardwareUsing iGuardware IGuard UtilitySetup Wizard IGuard Setup WizardIGuard Network Setup IGuard a/DSL Setup IGuard PPPoE Setup Launch iGuardManagerChapter.5 Click either one to Launch iGuard IP Configuration IGuard Web ManagerIP Configuration Set an IP Address for iGuard Device Password Reset Device PasswordUpgrade Firmware Ii. Management ProtocolIGuardware IGuardView IGuardView Screen ShotDevice Setting IGuardware Camera Setting Motion Detection Setting REDAvifilethree digit numerical sequence Server Authentication Email Notification SettingEmail Address Snmp Setting Using Snmp to update network portsCamera Monitor IGuardware IGuardware View SystemHelp IGuard Web Manager IntroductionIGuard Web Manager Web-Camera Selection System Information Information System StatusIi. Network Status Current Connections IGuard System StatusEvent Log IGuard Current ConnectionsBasic Settings Camera Settings Setting up Camera a Similar with Camera BIndividual Camera Configuration Network IP AddressIi. DNS Server IP Iii. Port NumberDynamic DNS Iv. EthernetVi. PPPoE Account Settings User Account User NameCamera Advanced Settings Event Notification IGuard Permit Hours ConfigurationEvent Notification Send Email IGuard Event NotificationIGuard Event Selection List IGuard Event Start Up Camera a or Camera B Enable Motion DetectionIGuard Motion Detection IGuard Motion Detect Email Notification Image Recording Camera a or Camera B Begin End hhmmMail / FTP IGuard Email of Image RecordedFTP Settings FTP Server Ii. Email Settings E-mail ServerIii. Sending Test Mail IGuard test mail functionIv. Email Address Book System SettingsSystem Time Iv. Snmp Settings Iii. LED SettingsIi. System Restart Snmp setting AboutIi. Save / Restore Settings Save current Configuration AboutDdns Port Forwarding Appendix a Router ConfigurationDemilitarized Zone DMZ BEFSR41 Appendix a Router Configuration Type in the camera’s IP address UDPDescription IGuard Camera Internet Port 9001 to Type TCP Appendix a Router Configuration Dell TrueMobile 2300 Wireless Broadband Router Appendix a Router Configuration Appendix a Router Configuration Appendix a Router Configuration Action Allow always Appendix a Router Configuration TCP Type in the camera’s IP address Appendix a Router Configuration TCP Appendix a Router Configuration Appendix B IP Address, Subnet and Gateway Subnetting and Subnet Masks Subnet Mask Routing and FilteringAppendix C Glossary Term DefinitionAppendix D Q&A Q2. Can I use other USB Camera to connect to iGuard?Q5. What is the effective length of the USB cable? If iGuard is connected to a Router or IP Share then Q13. There is no Port Forwarding Section in my Router Appendix D Glossary