Micon IP-220E manual Web-Camera Selection

Page 36

Chapter 5: iGuard Web Manager

5.2.1 Web-Camera Selection

Click on either “ActiveX” or “Sun Java” from Camera A or B to view the camera images.

By default the first USB camera connected to iGuard will be denote as “Camera A”

Click “Camera B” to view camera B.

Note: ActiveX can only function on Windows platform and a plug-in has to be installed on the client's computer. If this is prohibited for safety reasons you will have to use Sun Java to view the video feed. Sun Java also allows users who are not

using Windows based Operating System to view the video feed.

Once you click on “Camera A” the following image will appear.

Make sure to adjust the USB camera lens for best picture results.

Click on the controls along the

Window to control the camera.

Note:

The pan and tilt controls will only work with cameras which has this function built-in.

Click to record the current image to the selected directory. To change the saved

location and filename. Click and the “Save As” window will pop up. Choose an alternate location and filename. Click the “Save” button to confirm changes.

35

Image 36

Contents IGuard Contents Page Features IntroductionPackage Contents IGuard IP-220E Hardware Light color Condition descriptionHardware Installation Installation Procedure StepInstalling iGuardware IGuardwareUsing iGuardware IGuard UtilitySetup Wizard IGuard Setup WizardIGuard Network Setup IGuard a/DSL Setup IGuard PPPoE Setup Launch iGuardManagerChapter.5 Click either one to Launch iGuard IP Configuration IGuard Web ManagerIP Configuration Set an IP Address for iGuard Device Password Reset Device PasswordUpgrade Firmware Ii. Management ProtocolIGuardware IGuardView IGuardView Screen ShotDevice Setting IGuardware Camera Setting Motion Detection Setting REDAvifilethree digit numerical sequence Email Notification Setting Server AuthenticationEmail Address Snmp Setting Using Snmp to update network portsCamera Monitor IGuardware IGuardware View SystemHelp IGuard Web Manager IntroductionIGuard Web Manager Web-Camera Selection Information System Status System InformationIi. Network Status Current Connections IGuard System StatusEvent Log IGuard Current ConnectionsBasic Settings Camera Settings Setting up Camera a Similar with Camera BIndividual Camera Configuration Network IP AddressIi. DNS Server IP Iii. Port NumberIv. Ethernet Dynamic DNSVi. PPPoE Account Settings User Account User NameCamera Advanced Settings Event Notification IGuard Permit Hours ConfigurationEvent Notification Send Email IGuard Event NotificationIGuard Event Selection List IGuard Event Start Up Camera a or Camera B Enable Motion DetectionIGuard Motion Detection IGuard Motion Detect Email Notification Image Recording Camera a or Camera B Begin End hhmmMail / FTP IGuard Email of Image RecordedFTP Settings FTP Server Ii. Email Settings E-mail ServerIii. Sending Test Mail IGuard test mail functionSystem Settings Iv. Email Address BookSystem Time Iii. LED Settings Iv. Snmp SettingsIi. System Restart Snmp setting AboutIi. Save / Restore Settings Save current Configuration AboutAppendix a Router Configuration Ddns Port ForwardingDemilitarized Zone DMZ BEFSR41 Appendix a Router Configuration Type in the camera’s IP address UDPDescription IGuard Camera Internet Port 9001 to Type TCP Appendix a Router Configuration Dell TrueMobile 2300 Wireless Broadband Router Appendix a Router Configuration Appendix a Router Configuration Appendix a Router Configuration Action Allow always Appendix a Router Configuration TCP Type in the camera’s IP address Appendix a Router Configuration TCP Appendix a Router Configuration Appendix B IP Address, Subnet and Gateway Subnetting and Subnet Masks Subnet Mask Routing and FilteringAppendix C Glossary Term DefinitionAppendix D Q&A Q2. Can I use other USB Camera to connect to iGuard?Q5. What is the effective length of the USB cable? If iGuard is connected to a Router or IP Share then Q13. There is no Port Forwarding Section in my Router Appendix D Glossary