Micon IP-220E manual Appendix a Router Configuration

Page 68

 

Appendix A: Router Configuration

Enabled/Disabled:

Enabled

For ID#2

 

Service Port:

9001

Service IP:

Type in the camera’s IP address, for example: 192.168.0.5

Enabled/Disabled:

Enabled

4.Save your settings. iGuard should now be configured to work with your router and be accessible from the internet.

DI714

1.Log into your router using your router IP.

2.On the main page, click on Advanced at the top of the page.

3.Click on Virtual Server Settings on the left side of the page.

4.Enter the camera’s IP address into the Internal IP field. Under Service, select All and then click Submit to save your settings. iGuard should now be configured to work with your router and be accessible from the internet.

DI-714P+

1.Log into your router using your router IP.

2.On the main page, click on Advanced at the top of the page.

3.On the left side of the page, click Virtual Server.

4.Enter the following information on the page:

For ID#1:

 

Service Port:

80

Service IP:

Type in the camera’s IP address, for example: 192.168.0.5

Enabled/Disabled:

Enabled

For ID#2

 

Service Port:

9001

Service IP:

Type in the camera’s IP address, for example: 192.168.0.5

Enabled/Disabled:

Enabled

5.Click Apply to save your settings. iGuard should now be configured to work with your router and be accessible from the internet.

67

Image 68
Contents IGuard Contents Page Features IntroductionPackage Contents IGuard IP-220E Hardware Light color Condition descriptionHardware Installation Installation Procedure StepInstalling iGuardware IGuardwareUsing iGuardware IGuard UtilitySetup Wizard IGuard Setup WizardIGuard Network Setup IGuard a/DSL Setup IGuard PPPoE Setup Launch iGuardManagerChapter.5 Click either one to Launch iGuard IP Configuration IGuard Web ManagerIP Configuration Set an IP Address for iGuard Device Password Reset Device PasswordUpgrade Firmware Ii. Management ProtocolIGuardware IGuardView IGuardView Screen ShotDevice Setting IGuardware Camera Setting Motion Detection Setting REDAvifilethree digit numerical sequence Email Address Email Notification SettingServer Authentication Snmp Setting Using Snmp to update network portsCamera Monitor IGuardware IGuardware View SystemHelp IGuard Web Manager IntroductionIGuard Web Manager Web-Camera Selection Ii. Network Status Information System StatusSystem Information Current Connections IGuard System StatusEvent Log IGuard Current ConnectionsBasic Settings Camera Settings Setting up Camera a Similar with Camera BIndividual Camera Configuration Network IP AddressIi. DNS Server IP Iii. Port NumberVi. PPPoE Iv. EthernetDynamic DNS Account Settings User Account User NameCamera Advanced Settings Event Notification IGuard Permit Hours ConfigurationEvent Notification Send Email IGuard Event NotificationIGuard Event Selection List IGuard Event Start Up Camera a or Camera B Enable Motion DetectionIGuard Motion Detection IGuard Motion Detect Email Notification Image Recording Camera a or Camera B Begin End hhmmMail / FTP IGuard Email of Image RecordedFTP Settings FTP Server Ii. Email Settings E-mail ServerIii. Sending Test Mail IGuard test mail functionSystem Time System SettingsIv. Email Address Book Ii. System Restart Iii. LED SettingsIv. Snmp Settings Snmp setting AboutIi. Save / Restore Settings Save current Configuration AboutDemilitarized Zone DMZ Appendix a Router ConfigurationDdns Port Forwarding BEFSR41 Appendix a Router Configuration Type in the camera’s IP address UDPDescription IGuard Camera Internet Port 9001 to Type TCP Appendix a Router Configuration Dell TrueMobile 2300 Wireless Broadband Router Appendix a Router Configuration Appendix a Router Configuration Appendix a Router Configuration Action Allow always Appendix a Router Configuration TCP Type in the camera’s IP address Appendix a Router Configuration TCP Appendix a Router Configuration Appendix B IP Address, Subnet and Gateway Subnetting and Subnet Masks Subnet Mask Routing and FilteringAppendix C Glossary Term DefinitionAppendix D Q&A Q2. Can I use other USB Camera to connect to iGuard?Q5. What is the effective length of the USB cable? If iGuard is connected to a Router or IP Share then Q13. There is no Port Forwarding Section in my Router Appendix D Glossary