Rockford Fosgate PSD-1 manual Both Power and/or

					TROUBLE-S
						H
						O
						O
						T
						I
						N
						G
Symptom		Diagnosis		Remedy
PSD does not	Amplifier has		over-	Turn the system off and wait
turn on (Thermal	heated and activated its			approximately 15 minutes for
LED on)	thermal protection			the amplifier to cool down.
	Voltage applied to the			Check wiring and repair if
	amplifier Remote Turn-			necessary. If voltage is above
	On is not between 8 and			15.5 volts, have the electrical
	15.5 volts			system inspected by an au-
				thorized car service center
Random LEDs	Stereo amplifier is not			Connect stereo amplifier to
	connected to		proper	Stereo/Mono Left input only
Illuminate
	input
	Single Mono amplifier			Connect single Mono ampli-
	is not connected to			fier to Stereo/Mono Left input
	proper input			only
Both POWER and/or	Stereo/Mono jumpers			Check jumper configurations
THERMAL LEDs do	are	removed	from	and repair as necessary
not illuminate	jumper pins
(Stereo Amp Con-
nected)
Both POWER and/	Stereo/Mono jumpers			Check jumper configurations
or THERMAL LEDs	are installed on jumper			and repair as necessary
illuminate (Mono	pins
Amp Connected)
LEDs do not dim	Voltage applied to the			Connect voltmeter to source
(Headlights	Dim (orange) wire is not			of switched +12 volts and
turned on)	between 10.5 and 15.5			verify voltage. Repair wiring
	volts			as necessary or find an alter-
				nate +12 volt source
	Dim (orange) wire is not			Repair wiring as necessary or
	connected to a source			find an alternate +12 volt
	that	switches to +12		switched source
	volts when the head-
	lights are turned on
PSD shuts off when	Voltage applied to the			Check wiring and repair if
amp thermals	Remote Turn-On (blue)			necessary. If voltage is above
(Remote Enabled)	wire is not between 8			15.5 volts, have the electrical
	and 15.5 volts or there			system inspected by an au-
	is no voltage present			thorized car service center

– 15 –