Rockford Fosgate FNQ3514 Wiring Tweeter to Crossover, Installation-Speakers, Setting Crossover

INSTALLATION-TWEETERS

Wiring Tweeter to Crossover

1.Use illustrations for proper connection.

2.Be sure to maintain speaker polarity

Setting Crossover

A0°/180° Tweeter Phase matches the phase response of the tweeter to the midrange (eminent when tweeter is located away from the midrange). Leave the switch in the position that results in the best sound quality.

B0dB Tweeter Level matches the amplitude of the tweeter to the midrange

C-3dB/-6dB Tweeter Level reduces the amplitude of the tweeter -3dB or -6dB lower than the midrange. (ex. ideal for tweeters located high in door panels and midranges located low in the kick panel)

DReplaceable Tweeter Protection Bulb acts as a fuse to protect against overload. If the bulb burns out, remove the burned out bulb and insert a new bulb (part# HDW10932) into the retainer clips.

A

B

C

One Channel from Source or Amplifier

Tweeter or System Crossover

D

Tweeter

Mid Range

Use this when installing Tweeters or Systems

INSTALLATION-SPEAKERS

Use this section when installing Systems, Mid Bass, or 3-Way

1. Cut the proper size hole for the speaker.

NOTE: See Specifications for proper hole size.

2.Place the mounting ring over the mounting hole and mark the location of the screw mounting holes.

6