Installation Guide
WARNING
This installation information is designed for experienced installers and is not intended for
Any attempt to install this product in a motor car by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death.
E
N
G
L
I
S
H
10
❏Overview
This product should be installed by a professional. However, if you plan to install this unit yourself, your first step is to decide where to install it. The instructions in these pages will guide you through the remaining steps: (Please refer to “WARNING” statement above).
●Identify and label the vehicle wires.
●Connect the vehicle wires to the wires of the power connector.
●Install the unit in the dash.
●Check the operation of the unit.
If you do encounter problems, please consult your nearest professional installer.
Caution: This unit will operate with a 12 volt DC negative ground auto battery system only. Do not attempt to use it in any other systems. Doing so could cause serious damage.
Before you begin installation, look for the following items included in the packing with your unit.
❏Installation Hardware
No. | Item | Diagram Q’ty | |
Mounting Collar | 1 | ||
Hex. Nut (5 mmφ ) | 1 | ||
Rear Support Strap | 1 | ||
Tapping Screw | 1 | ||
(5 mmφ | x 16 mm) | ||
| |||
Mounting Bolt (5 mmφ ) | 1 | ||
Power Connector | 1 | ||
Dismounting Plate | 1 | ||
Removable Face | 1 | ||
Plate Case | |||
| |||
● Warranty Card . . . . . . . . . . . . .Fill this out promptly
●Panasonic Servicenter for service
Directory . . . . . . . . . . . . . . . . .Keep this for future reference in case the unit needs servicing ● Installation Hardware . . . . . . .Needed for
19