E N G L
Installation Guide continued
I
S
H
13
Motor Antenna
Connect the car motor antenna lead to the blue motor antenna relay control lead.
Battery
Connect the yellow battery lead to the correct radio wire or to the battery fuse port on the fuse block.
Antenna
Connect the antenna by plugging the antenna lead into the antenna receptacle.
Product
Connect any optional product such as amplifier, according to the instructions furnished with the product. Keep about 12 inches (30 cm) of distance between the speaker cords/amplifier unit and the antenna/antenna extension cord. Read the operating and installation instructions for any product you will connect to this unit.
Power
Connect the red power lead to the correct car radio wire or to the appropriate fuse port on the fuse block.
If the stereo unit functions properly with all these connections made, disconnect the wires and proceed to the final installation.
❏Final Installation
Lead Connections
Connect all wires, making sure that each connection is insulated and secure. Bundle all loose wires and fasten them with tape so they won't fall down later. Now insert the stereo unit into the mounting collar.
Congratulations! After making a few final checks, you’re ready to enjoy your new auto stereo system.
❏Final Checks
1.Make sure that all wires are properly connected and insulated.
2.Make sure that the stereo unit is securely held in the mounting collar.
3.Turn on the ignition to check the unit for proper operation.
If you have difficulties, consult your nearest authorized professional installer for assistance.
❏Precautions
●When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and fingers.
●We strongly recommend you to wear gloves for installation work to protect yourself from injuries.
❏Installation Procedures
1. Secure the Mounting Collar .
Insert Mounting Collar into the car’s dashboard, and bend mounting tabs out with a screwdriver.
Mounting Tab
Dashboard
Mounting Collar
22
Screwdriver