Kenwood TS-570D, TS-570S, TS-570S, TS-570D instruction manual Microphone

PF	POWER
					HF TRANSCEIVER TS-570D
ATT	PRE-AMP
VOX	PROC
SEND	AT TUNE
		CH1	CH2	CH3	MIC	LSB
PHONES		1	2	3
						USB
		ANT	REC	FINE	PWR	CW
		4	5	6
						FSK
MIC		NB	AGC/TONE REV		KEY
						FM
		7	8	9
						AM
			F.LOCK		DELAY	MENU 1MHz

CLR 0 ENT

@6DSP SLOPE (HIGH) control

In SSB or AM mode, turn to change the high cut-off frequency of the receive pass band. Use the control to improve readability of the desired signal when higher frequency interference is present {page 37}.

@7DSP SLOPE (LOW) control

In SSB or AM mode, turn to change the low cut-off frequency of the receive pass band. Use the control to improve readability of the desired signal when lower frequency interference is present {page 37}.

@8RIT/XIT control

After switching ON the RIT or XIT function, turn to select the desired frequency offset {pages 30, 32}.

@9AF control

Turn to adjust the audio frequency gain {page 13}.

#0RF control

Turn to adjust the radio frequency gain {page 13}.

#1IF SHIFT control

Turn to slide the receive pass band either lower or higher in frequency when interference is present {page 36}.

#2SQL control

Used for muting (“squelching”) the speaker output when no receive signal is present {page 14}.

#3MULTI/CH control

In VFO mode, turn to step the operating frequency up or down {page 29}. In memory channel mode, turn to select a memory channel {page 40}. Also used for selecting Menu numbers when accessing the Menu mode {page 16}, and as a selector to choose settings for various functions activated by front panel buttons.

3 GETTING ACQUAINTED

@8

		DSP SLOPE
	N.R.	HIGH	LOW
	B.C.	T	I
		U	H	@6
			G
		L	H
		C
		W	C
		O
	CW TUNE		TU	@7
	FILTER	AF	RF
UP	RIT/XIT	4	6

DOWN

		MR						@9
			M.IN	–	+	2	8
						0	10	#0
SPLIT	TF-SET	A/B	RIT	CH		IF SHIFT	SQL
						4	6
M/V	A=B	CLEAR	XIT					#1
SCAN	M>VFO		M.IN			2	8
								#2
						0	10

#3

MICROPHONE

qUP/DWN buttons

Use these buttons to step up or down the VFO frequency, memory channels, or Menu selections. Press and hold down to continuously change the settings.

wPTT (Push-to-Talk) switch

The transceiver is placed in transmit mode when this non-locking switch is held down. Releasing the switch returns the transceiver to receive mode.

q

DWN UP

w

PTT

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

9