| 10 MEMORY FEATURES | |
STORING FREQUENCY RANGES | ■ Confirming Start/End Frequencies | |
Memory channels 90 to 99 allow you to store frequency | Use this procedure to check the start and end | |
ranges for VFO tuning and Program Scan. Program | frequencies that you stored in channels 90 to 99. | |
Scan is described in the next chapter. To tune or scan | 1 Press [M/V] to enter Memory Recall mode. | |
frequencies in a desired range only, store start and end | ||
2 Turn the MULTI/CH control, or press Mic [UP] or | ||
frequencies for that range in advance. | ||
1 Press [A/B] to select VFO A or VFO B. | [DWN] to select a memory channel. | |
|
1
2
•“tA” or “tB” appears to show which VFO is selected.
2Select the end frequency and mode.
3Press [A/B] to select the other VFO.
4Select the start frequency.
5Press [SPLIT].
• “SPLIT” appears.
6Press [M.IN] to select Memory Scroll mode.
•To exit Memory Scroll mode and abort the storage process, press [CLR].
7Turn the MULTI/CH control, or press Mic [UP] or [DWN] to select a memory channel in the range from 90 to 99.
•Entering a
3Press [DOWN] to check the start frequency and press [UP] to check the end frequency.
■Programmable VFO
Using the start and end frequencies that you stored in channels 90 to 99, Programmable VFO restricts the frequency range that you can tune with the Tuning control. One application of this function is to help you operate within the authorized frequency limits of your license.
1Press [M/V] to enter Memory Recall mode.
2Turn the MULTI/CH control, or press Mic [UP] or [DWN] to select a memory channel.
Now you can only tune from the start frequency to the end frequency
ERASING MEMORY CHANNELS
If there are memory channels that you will not recall in the future, you may prefer erasing the contents of those channels.
1Press [M/V] to enter Memory Recall mode.
2Turn the MULTI/CH control, or press Mic [UP] or [DWN] to select a memory channel.
3Press [CLR] for approximately two seconds.
•A beep sounds to confirm that the channel data is erased.
■Full Reset
Do Full Reset if you want to erase all data in all memory channels. Note that this function resets all settings, that you customized, to the factory defaults, i.e. menu settings, quick memory, etc.
To do Full Reset, press [A=B]+ POWER ON.
3
4
5
6
7
8
9
10
11
12
13
8Press [M.IN] again to store the data.
•The previous data stored in the channel is overwritten.
14
15
16
43