Alpine DVA-9965 owner manual Storing Settings in the Memory, Getting out the Preset Memory, 53-EN

Storing Settings in the Memory

Up to 6 settings can be stored on the unit.

All settings and adjustments described below are stored in one memory preset.

Setting/adjusting items	Refer to page
Setting the Speakers	46
Setting Time Correction/Switching Phase	47, 48
Adjusting EQ	48, 49
Adjusting X-OVER	46
Setting MX	46
Setting BASS COMP.	49
Setting PRO LOGIC II/Adjusting the	52
Centre Width*
Adjusting Dolby Surround*	50, 51
Linear PCM Setting*	52

* Depending on the input signal, sound effect may not be obtained.

1

2

Press MENU.

Touch the GlideTouch bar, select AP Preset Mode by sliding it to the left or right, then press GlideTouch bar.

3Touch the GlideTouch bar, select the preset number (1 through 6) by sliding it to the left or right, then press and hold the GlideTouch bar for at least 2 seconds to store the adjusted contents.

•This function is operable only when Defeat is set to OFF.

•The stored contents will not be deleted even when battery power cord is detached.

Getting out the Preset Memory

1Check that Defeat mode is off (page 20).

2Press MENU.

3Touch the GlideTouch bar, select AP Preset mode by sliding it to the left or right, then press the GlideTouch bar.

4Touch the GlideTouch bar, and select a preset number (1 through 6) you wish to recall by sliding it to the left or right, then press the GlideTouch bar.

• It takes a few moment to get out the preset memory.

53-EN