DVD/Video CD
SOURCE/POWER
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| f | FUNC. | GlideTouch bar |
|
| ||||
|
| |||||||||
g |
|
|
| c | ||||||
; | 8 | |
| : | |
RETURN | ENT. | |
9 | ||
| ||
g | f | |
:/J | ||
number | ||
| ||
L | keys | |
MENU | (0 to 9) | |
| ||
CLR |
|
DISP/TOP M.
ANGLE
AUDIO | SUBTITLE |
•DVD and Video CD operation can be controlled from both the remote control and the main unit. In this section, both remote control and main unit operation are described.
For GlideTouch bar details, refer to page 20.
•To view DVD and Video CD, the optional TV monitor is required.
•If a PAL type disc is inserted, the message “VIDEO SIGNAL SYSTEM IS NOT CORRECT” is displayed, and playback is not available.
Playing DVD/Video CD
Caution
•Not all functions will be operated for every DVD. See the individual DVD’s instructions for details on the features supported.
•Fingerprints on a disc may adversely affect playback. If a problem occurs, remove the disc and check for fingerprints on the playback side. Clean the disc if necessary.
•When using the remote control, be careful to press only one button at a time. Pressing multiple buttons at the same time may cause erroneous operation.
•If you try to perform an invalid operation (based on the type of disc being played), the following mark is displayed on the monitor screen: 
Play Position Memory Function
Even if you turn power off or switch the Ignition Key to OFF during playback or change the source, playback will continue from the point where playback stopped when the power is turned ON again.
1Insert a disc with the label side facing up. The disc will be pulled into the unit automatically.
When a disc is already inserted, press SOURCE/POWER on the main unit to switch to the DISC mode.
The mode will change every time the button is pressed.
DISC → TUNER → CD CHANGER* → DISC
* Only when the CD changer is connected
2To eject the disc, press c on the main unit.
•Do not remove a disc during its eject cycle. Do not load more than one disc at a time. A malfunction may result from doing either.
•If the disc does not eject, press and hold c for at least 2 seconds.
•The reverse side of a
•Never insert map discs for navigation purposes as they could damage the equipment.
•Refer also to “DVD Setup” (pages 32 to 34).
If a menu screen appears
On DVDs and video CDs with playback control (PBC), menu screens may appear automatically. If this happens, perform the operation described below to start playback.
•This operation is controlled using the remote control unit.
•For many discs,the menu screen can also be displayed by pressing MENU.
DVD menu
Press 8, 9, ; or : to select the desired item, then press ENT.
•For some discs it is possible to select items directly from the menu screen using the number keys (“0” to “9”).
Video CD menu
Use the number keys (“0” to “9”) to select the desired number, then press ENT.
•The menu screen does not appear when the PBC function is turned off. In this case, set VCD PLAY MODE to turn on the PBC function. For details, refer to “Setting the Video CD Play Mode” (page 35).