Sharp MD-MS702, MD-R2 To interrupt playback, To stop playback, To turn off the power

Page 23

To interrupt playback:

Press the 06 button during playback.

●To resume playback, press the 06 button again.

To stop playback:

Press the ■/:OFF button.

●When you press the 06 button to re- sume playback, it will start at the point on the disc where playback was halted (Resume function). However, if the MiniDisc is removed and reinserted, playback will start from the first track.

To turn off the power:

Press the ■/:OFF button while in the stop mode.

●If the unit is not operated for at least 2 minutes while in the stop mode, the power will be turned off automatically.

To remove the MiniDisc:

Turn off the power and move the EJECT lever in the direction indicated by the arrow.

When using the unit with just the batteries in the battery case:

●The auto-play function will not work.

●To start playback, hold down the 06 button for about 1 second.

●Even if a MiniDisc is replaced while the power is turned off, the random or repeat play settings will remain unchanged in memory.

Precautions when making connec- tions:

●Do not use any remote control unit, except for the one included with this unit.

●Insert each plug securely, all the way in.

●Be sure to hold the plug when removing it. If you pull on the cord, it may break, or the unit may malfunc- tion.

Interrupted sound:

●This product is designed to eliminate interruptions in the sound which can be caused by vibrations. However, if the unit is continuously exposed to vibrations or mechanical shock, the sound may be interrupted momen- tarily.

When the sound is distorted:

●If the volume is too high while the bass is being emphasized, the sound may be distorted, depending on the music on the track. If this happens, decrease the bass level or lower the volume level.

●If the volume is increased to “VOL 26" or higher, the bass level will be adjusted automatically.

(This is done to reduce the distortion in the sound.)

Cautions:

●When the unit is not to be used im- mediately after a MiniDisc has been inserted, or when you plan to carry the unit, turn off the power or cancel the auto-play function. Otherwise, the auto-play function will be ac- tivated and the batteries will run down.

●Since the main unit and the AC adaptor can heat up during use, you should avoid allowing the unit to be in direct contact with your skin for any length of time.

When using the unit with a car adaptor:

●When switching off the ignition during playback, the power to this unit will also be turned off. When the ignition is switched on, playback will start from the beginning of the track where playback was halted (Resume auto-play function). However, the power to the unit may not be turned off when the ignition is turned off, depending on the type of car.

22

MD-MS702

Page 22 Page 24
Image 23
Page 22 Page 24
Contents MD-MS702 Introduction ContentsAccessories Special Notes For Your RecordsPrecautions PrecautionsVolume setting Concern for others when Listening to MiniDiscsRemote control unit Names of Controls and IndicatorsMain unit 25 26Rechargeable battery power Power SourceAC power Alkaline battery powerDigital recording Before RecordingType of recording Analog recordingPlayback-only MiniDisc Recordable MiniDisc Types of discsTo prevent recorded discs from being erased accidentally To interrupt recording Recording Using the Cable Included with the UnitRecording from CDs or MDs Synchro recording Recording from a tuner or a CD Manual recording To stop recordingAfter recording To remove the MiniDiscManual recording Recording Using AN Optionally Available Digital CableThere are cases where digital recording may be impossible Start recording Synchro recordingRecording from the microphone Mic synchro recording Recording Using a MicrophoneTo interrupt a recording To interrupt a synchro recordingRecording from the microphone Mic manual recording About the timed auto mark When the timed auto mark setting has been changedConvenient Recording Function To start recording from Middle of an existing track Recording tracks as a single trackMaking a track number automatically To create your own track numbers while recording Double time recording in monaural modeTo check the remaining disc time To erase all of the tracks at once To erase tracks To erase tracks one at a timeAbout Track Numbers When recording from digital inputs CDs/MiniDiscs onlyAbout the TOC About TOC recording When is the TOC recorded?Playing a Minidisc Playback does not start when a MiniDisc is insertedTo stop playback To turn off the powerTo interrupt playback To re-start the track being played Convenient Playback FunctionsCue and review To move to the beginning of the next trackTo interrupt fast playback To play at double speed Mono recording onlyRandom play or repeat play To check individual track names one by one To check the elapsed time and remaining time of the trackName/stamp EditingWhat the editing function can do Disc/Track nameDivide MoveTo combine two non-contiguous tracks When one or both tracks to be combined have a nameCombine Disc nameIf an incorrect letter is entered Track nameTo add characters To change track names or disc namesTo change characters To delete charactersPage Listening through a car stereo Using with Other EquipmentListening through commercially available headphones To prevent the unit from being operated by mistake Convenient Operation FeaturesChecking the remaining amount of battery charge How to read the battery indicatorTo turn off the display backlight While in the stop modeTo eliminate the confirmation SoundAbout the sound skip guard memory To cancel the auto-play functionTo cancel the auto power save function About the auto power save functionTroubleshooting What is a MINIDISC?If trouble occurs Minidisc System Limitations Batt Empty Error MessagesGeneral MaintenanceSpecifications CleaningMiniDisc Recorder Memo Limited Warranty
Top Page Image Contents