Kathrein CAP 700 manual Version with External Cable Gland FIG. F

Page 16

INSTALLATION AND CONNECTION

VERSION WITH EXTERNAL CABLE GLAND (FIG. F)

Direction of travel

Cables laid in the cable duct*) and water-tight roof gland*)

*) Not supplied! The HDZ 100 roof gland is available as an accessory under part number 20410032 from specialist dealers.

The external roof gland is arranged so that it forms a water-tight enclosure on the vehicle roof around the point where the two cables projecting from the turntable are connected to the two extension cables within the interior of the vehicle, and where if necessary they can be disconnected.

Arrange the cables in the cable duct when placing the turntable on to the mounting plate. Make sure that the cables are not crossed over and that they are taut so that they cannot be crushed. Do not try to pull the cables from the unit. This could damage the cables or loosen the cable connections.

Place the turntable carefully on the mounting plate. The through holes on the turntable must be perfectly aligned with the threaded holes on the mounting plate.

Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening screws into the thread. Tighten the screws to a torque of 6 Nm.

When feeding the cables through the HDZ 100 roof gland, make sure they are not crushed, kinked or damaged.

16

Image 16
Contents CAP Contents Disposal Instructions Foreign Language Installation MANUALS/DISPOSALSpent batteries are special waste Mobiset 3 CAP 700 COMPONENTS/SCOPE of Delivery Product PackageProper USE Proper USE USE for the Intended PurposeEssential information Safety Instructions Important NotesAdhesive sealant Power supply, fusing Road Traffic Licensing Regulations StVZOChecks before commencing a journey Installation and Connection Selecting the Installation LocationRequired Tools and Equipment Unpacking and PreparationDirection of travel Installation Steps Ring AdhesiveArrow in the direction of travel Recess for cable Adhesive areas between the two grooves Installation of Turntable Direction of travel Version with External Cable Gland FIG. F Brief Instructions for Installing the Turntable Tightening torque 6 Nm Suspended Installation Installation on a Fixed Flat Surface They must not be reversed or the unit will not function Installation and Connection Connection Example for 12 V Battery Connection Reception RANGE/FOOTPRINT Address of the Service Centre Dismantling for ServicingESC DismantlingPolarisation Setting Polarisation SettingAstra Eutelsat Safety Notes Setting OperationsView after installation +45 Manual Lowering to Park Position Manual Lowering Technical Data Dimensions MMTechnical Data Type CAP Sikaflex 291 Safety Data Sheet Materials/preparation and company designationComposition/data on components Potential hazardsMeasures for fire fighting Measures if inadvertently releasedHandling and storage Exposure limitation and personal protective equipmentPhysical and chemical characteristics Stability and reactivityToxicology data Sensitisation Ecological dataDisposal instructions Transport dataOther data Sikaflex 291 Technical Data Sheet Sikaflex-291 IkaflexChemical Stability CAP 700 Operating Manual Important Information for CAP 700 Before Setup Remote ControlFirst Installation Page TV aspect ratio Picture formatTV Scart Output SystemLocal time offset Alignment Satellite Search Moving the Antenna Manually Channel Satellite Selection Channel Selection from the Channel ListTimer Programming Change of LOCATION/TIMER ProgrammingMoving towards RESET/PARKING Resetting the Turn Table AntennaParking the Turntable Special Messages from the Turntable System Protection MessagesSpecial Messages from the Turntable Messages Arising from Software Problems Further Messages Declaration of Conformity For Your Notes 936.3417/-/0908/ZWT Technical data subject to change
Related manuals
Manual 1 pages 14.04 Kb