CHANGE OF LOCATION/TIMER PROGRAMMING
After a change of location, the antenna moves to the last position selected. After initialisation, you will therefore see the following display (example, as it depends on the last selected position):
For slight changes of location, the antenna can find the satellite very quickly.
If the satellite is not found at the | moving towards ... |
known position, the search starts |
|
automatically. |
|
If the search is unsuccessful, the following message appears: |
|
If you still want to aim at the satellite, press the button to start the search.
If a signal is found, the antenna automatically goes into fine tuning mode (max. 90 seconds, if signal is adequate the position is immediately saved).
TIMER PROGRAMMING
See the UFS 740sw operating manual for details of how to program the timer. When using the UFS 740sw on a CAP 700 please note the following additional instruction:
To prevent the turntable rotating at a time when it is unsupervised or when rotation might be irritating (e.g. in the middle of the night), a timer can be set. During the timer period the turntable is active only if the UFS 740sw is in operation or is in standby mode.
If the receiver is completely switched off (switched off at the power socket) and/ or the turntable is in park position, the turntable will be inactive during the timer period! The same applies if during the first movement the satellite position is not found.
51