Kathrein CAP 700 manual Checks before commencing a journey

Page 8

SAFETY INSTRUCTIONS - IMPORTANT NOTES

The antenna will be lowered within 12 seconds of the ignition being switched on (if the unit is in stand-by mode or the UFS 740sw is switched off). Otherwise the control unit that is in use is lowered immediately.

Important: Lowering the antenna can take up to 30 seconds after the ignition is switched on!

Checks before commencing a journey

Before commencing a journey, the antenna must always be lowered into horizontal position (park position). If the antenna has collided with a fixed or movable object, check that it is still securely attached.

As the antenna is subjected to vibration loads during driving, you should check at regular intervals, depending on the frequency of driving, that the system is still securely attached and tighten any parts that have worked loose.

The maximum permissible speed for vehicles with a receiver unit mounted on the roof and the antenna lowered is 130 km/h.

Lower the antenna if it will not be used for a long period. This makes the securing bolts more difficult to access (protection against theft).

Antenna in the park position whilst driving

The antenna must always be lowered into horizontal position (park position) while driving. As a reminder, attach the sticker from the supplementary sheet “Lower the CAP 700 antenna while driving” where it can easily be seen by the person operating the ignition switch.

Safety precautions during operation

During operation of the turntable, make sure that no persons, in particular children, are in the immediate vicinity of the turntable and that they cannot touch any moving parts – crush hazard!

Always unplug the power supply during installation work.

Exceeding the normal vehicle height by failing to lower the antenna increases the risk of accidents! The driver is responsible for the condition of external fittings on the vehicle!

In addition the instructions in the installation and operating manuals for these devices and for the attachments and superstructures must be complied with at all times!

If stormy weather is expected, the turntable must always be moved to the park position, otherwise both the CAP 700 and the vehicle may be damaged.

8

Image 8
Contents CAP Contents Spent batteries are special waste Foreign Language Installation MANUALS/DISPOSALDisposal Instructions Mobiset 3 CAP 700 COMPONENTS/SCOPE of Delivery Product PackageProper USE Proper USE USE for the Intended PurposeAdhesive sealant Safety Instructions Important NotesEssential information Power supply, fusing Road Traffic Licensing Regulations StVZOChecks before commencing a journey Installation and Connection Selecting the Installation LocationRequired Tools and Equipment Unpacking and PreparationDirection of travel Installation Steps Ring AdhesiveArrow in the direction of travel Recess for cable Adhesive areas between the two grooves Installation of Turntable Direction of travel Version with External Cable Gland FIG. F Brief Instructions for Installing the Turntable Tightening torque 6 Nm Suspended Installation Installation on a Fixed Flat Surface They must not be reversed or the unit will not function Installation and Connection Connection Example for 12 V Battery Connection Reception RANGE/FOOTPRINT Address of the Service Centre Dismantling for ServicingESC DismantlingPolarisation Setting Polarisation SettingAstra Eutelsat Safety Notes Setting OperationsView after installation +45 Manual Lowering to Park Position Manual Lowering Technical Data Dimensions MMTechnical Data Type CAP Sikaflex 291 Safety Data Sheet Materials/preparation and company designationComposition/data on components Potential hazardsMeasures for fire fighting Measures if inadvertently releasedHandling and storage Exposure limitation and personal protective equipmentPhysical and chemical characteristics Stability and reactivityToxicology data Sensitisation Ecological dataDisposal instructions Transport dataOther data Sikaflex 291 Technical Data Sheet Sikaflex-291 IkaflexChemical Stability CAP 700 Operating Manual Important Information for CAP 700 Before Setup Remote ControlFirst Installation Page TV aspect ratio Picture formatTV Scart Output SystemLocal time offset Alignment Satellite Search Moving the Antenna Manually Channel Satellite Selection Channel Selection from the Channel ListMoving towards Change of LOCATION/TIMER ProgrammingTimer Programming RESET/PARKING Resetting the Turn Table AntennaParking the Turntable Special Messages from the Turntable System Protection MessagesSpecial Messages from the Turntable Messages Arising from Software Problems Further Messages Declaration of Conformity For Your Notes 936.3417/-/0908/ZWT Technical data subject to change
Related manuals
Manual 1 pages 14.04 Kb