INSTALLATION AND CONNECTION
INSTALLATION OF THE UFS 740SW RECEIVER
The turntable is controlled by the UFS 740sw
The cable lengths must be taken into account when choosing the installation location. For suspended installation use the installation kit supplied with the receiver.
Note: When choosing the installation location, bear in mind that the on/off switch and the slots for inserting common interface modules should always be accessible. The UFS 740sw is equipped with a power saving circuit and a separate infrared transmitter, which means that the unit does not need to be placed where it is visible. You can therefore fit the UFS 740sw out of sight in any location, e.g. on cupboard walls, side walls or the base of storage compartments.
In addition, the following points should be taken into account:
•The wall thickness at the installation location must be at least 12 mm, as otherwise the screws will break through on the other side or damage the surface
•The receiver must be placed in such a way as to allow sufficient air circulation behind, above and next to the unit (installation using the installation kit ensures this). Installation on
•Ensure that the cupboard or storage compartment in which the unit is housed is adequately ventilated, to prevent a build up of heat
•Take care when tightening the screws not to damage any cables etc. behind or in the wall
•The receiver is designed for installation in exclusively dry, interior locations. The installation location must be protected against moisture
•The connecting cables must be provided with strain reliefs
The receiver must be connected to no other power supply than 12 V DC. The receiver’s earth connection must be connected to the negative pole of the motor home or caravan battery.
SUSPENDED INSTALLATION
19