INSTALLATION AND CONNECTION
REQUIRED TOOLS AND EQUIPMENT
•Circular cutter, Ø 38 mm
•
•Power drill
•Galvanised round head screws, depending on the roof structure (Ø: 5 mm, sheet metal screws D 7981, depending on the roof structure) or round head screws D 7985 with washers and nuts
•Twist drill, Ø 2.5 or 5.5 mm
•Round file and/or emery paper
•Cleaning agent
•
•Knife
•
•Torque wrench capacity 6 to 11 Nm
•Hexagon socket key (5 mm)
•Two wooden beams for supporting the turntable
UNPACKING AND PREPARATION
The CAP 700 must not be mounted on the satellite dish, since this could cause it to distort. Keep the CAP 700 in its cardboard box for transport on to the vehicle roof.
Retain the original packaging, as if it is necessary to send the unit for repair transport damage cannot be ruled out and the manufacturer accepts no liability for possible damage.
Loosen the six fastening screws (width A/F: 10 mm). Carefully lift the turntable off the mounting plate and place it on the prepared wooden supports. Make sure that the cables are not crushed where they emerge from the underside of the turntable.
The CAP 700 packaging can be opened along both long sides. This allows easier access to the fastening screws.
SELECTING THE INSTALLATION LOCATION
Essentially, the cable lengths of the MobiSet 3 CAP 700 components allow you a free choice of installation location on your caravan or motor home.
However, you should take note of the following points:
•Before installation, you should find out whether the operating manual for your vehicle permits the fitting of
•For direct satellite reception, there should be no obstructions between the antenna and the satellite. Therefore, make sure that the antenna is not shadowed by roof extensions such as luggage racks, air conditioning units, solar panels, etc. The problem of shadowing applies also to the selection of the parking place for your vehicle. For
9