Kathrein CAP 700 manual View after installation +45

Page 29

POLARISATION SETTING

8.Press the  button and the turntable will move to the selected elevation angle.

9.Turn off the UFS 740 using the main switch on the front and disconnect it from the power.

10.Use the socket driver supplied (size 20) to slacken the securing screw of the clamp on the LNB.

11.Rotate the LNB by the required number of degrees (the scale is located on the bottom on the LNB).

Scale for polarisation

setting

12.Tighten the hexagon socket screw to a torque of 3.3-3.5 Nm.

13.Leave the installation location and reconnect the UFS 740sw to the power supply.

15.First switch the receiver on at the main switch, then press any of the numeric buttons.

16.Wait until the message “Position of Astra is not known. Start search?” is displayed – abort this

procedure using the  button.

17.Next, press the  button to go to the main menu and use the  buttons to move to the “Settings” menu item. Confirm the selection by pressing the  button. Use the  buttons to move to the

“Antenna Configuration” menu item. Confirm the selection by pressing the  button.

18Use the  buttons to move to the menu item “Reset the turn table antenna”. Confirm the selection by pressing the  button. Once the antenna has been reset, you can return to the normal TV picture by pressing the  button.

View after installation +45°

View after installation -45°

29

Image 29
Contents CAP Contents Spent batteries are special waste Foreign Language Installation MANUALS/DISPOSALDisposal Instructions Product Package Mobiset 3 CAP 700 COMPONENTS/SCOPE of DeliveryProper USE USE for the Intended Purpose Proper USEAdhesive sealant Safety Instructions Important NotesEssential information Road Traffic Licensing Regulations StVZO Power supply, fusingChecks before commencing a journey Selecting the Installation Location Installation and ConnectionRequired Tools and Equipment Unpacking and PreparationDirection of travel Ring Adhesive Installation StepsArrow in the direction of travel Recess for cable Adhesive areas between the two grooves Installation of Turntable Direction of travel Version with External Cable Gland FIG. F Brief Instructions for Installing the Turntable Tightening torque 6 Nm Suspended Installation Installation on a Fixed Flat Surface They must not be reversed or the unit will not function Installation and Connection Connection Example for 12 V Battery Connection Reception RANGE/FOOTPRINT Dismantling for Servicing Address of the Service CentreESC DismantlingPolarisation Setting Polarisation SettingAstra Eutelsat Setting Operations Safety NotesView after installation +45 Manual Lowering to Park Position Manual Lowering Dimensions MM Technical DataTechnical Data Type CAP Materials/preparation and company designation Sikaflex 291 Safety Data SheetComposition/data on components Potential hazardsMeasures if inadvertently released Measures for fire fightingHandling and storage Exposure limitation and personal protective equipmentStability and reactivity Physical and chemical characteristicsEcological data Toxicology data SensitisationDisposal instructions Transport dataOther data Sikaflex-291 Ikaflex Sikaflex 291 Technical Data SheetChemical Stability CAP 700 Operating Manual Remote Control Important Information for CAP 700 Before SetupFirst Installation Page Picture format TV aspect ratioTV Scart Output SystemLocal time offset Alignment Satellite Search Moving the Antenna Manually Channel Selection from the Channel List Channel Satellite SelectionMoving towards Change of LOCATION/TIMER ProgrammingTimer Programming Resetting the Turn Table Antenna RESET/PARKINGParking the Turntable System Protection Messages Special Messages from the TurntableSpecial Messages from the Turntable Messages Arising from Software Problems Further Messages Declaration of Conformity For Your Notes 936.3417/-/0908/ZWT Technical data subject to change
Related manuals
Manual 1 pages 14.04 Kb