Kathrein manual Important Information for CAP 700 Before Setup, Remote Control

Page 43

IMPORTANT INFORMATION FOR CAP 700 BEFORE SETUP

This section of the UFS 740 operating manual for the turntable assumes that the UFS 740 and the turntable have been properly installed and connected, as described in the installation and operating manuals!

If you have not yet done so, read the safety instructions at the beginning of the UFS 740sw operating manual and follow them when handling the UFS 740sw and the turntable!

Before setting up your satellite system, make sure that the location allows a free view to the satellite positions to the South and is not shadowed by trees or other obstructions. This will save you time and effort!

So as to avoid overheating the turntable motors, do not operate the motors continuously for longer than 10 minutes.

None of the search procedures initiated by the CAP 700 will require as much as 10 minutes operation. Only repeated unsuccessful search procedures or manual overrides by the user can cause this limit to be exceeded.

Reception

reception No

REMOTE CONTROL

All settings on the UFS 740 are made using the remote!

43

Image 43
Contents CAP Contents Disposal Instructions Foreign Language Installation MANUALS/DISPOSALSpent batteries are special waste Product Package Mobiset 3 CAP 700 COMPONENTS/SCOPE of DeliveryProper USE USE for the Intended Purpose Proper USEEssential information Safety Instructions Important NotesAdhesive sealant Road Traffic Licensing Regulations StVZO Power supply, fusingChecks before commencing a journey Unpacking and Preparation Installation and ConnectionSelecting the Installation Location Required Tools and EquipmentDirection of travel Ring Adhesive Installation StepsArrow in the direction of travel Recess for cable Adhesive areas between the two grooves Installation of Turntable Direction of travel Version with External Cable Gland FIG. F Brief Instructions for Installing the Turntable Tightening torque 6 Nm Suspended Installation Installation on a Fixed Flat Surface They must not be reversed or the unit will not function Installation and Connection Connection Example for 12 V Battery Connection Reception RANGE/FOOTPRINT Dismantling Address of the Service CentreDismantling for Servicing ESCPolarisation Setting Polarisation SettingAstra Eutelsat Setting Operations Safety NotesView after installation +45 Manual Lowering to Park Position Manual Lowering Dimensions MM Technical DataTechnical Data Type CAP Potential hazards Sikaflex 291 Safety Data SheetMaterials/preparation and company designation Composition/data on componentsExposure limitation and personal protective equipment Measures for fire fightingMeasures if inadvertently released Handling and storageStability and reactivity Physical and chemical characteristicsTransport data Toxicology data SensitisationEcological data Disposal instructionsOther data Sikaflex-291 Ikaflex Sikaflex 291 Technical Data SheetChemical Stability CAP 700 Operating Manual Remote Control Important Information for CAP 700 Before SetupFirst Installation Page System TV aspect ratioPicture format TV Scart OutputLocal time offset Alignment Satellite Search Moving the Antenna Manually Channel Selection from the Channel List Channel Satellite SelectionTimer Programming Change of LOCATION/TIMER ProgrammingMoving towards Resetting the Turn Table Antenna RESET/PARKINGParking the Turntable System Protection Messages Special Messages from the TurntableSpecial Messages from the Turntable Messages Arising from Software Problems Further Messages Declaration of Conformity For Your Notes 936.3417/-/0908/ZWT Technical data subject to change
Related manuals
Manual 1 pages 14.04 Kb