Kathrein CAP 700 Safety Instructions Important Notes, Essential information, Adhesive sealant

Page 6

SAFETY INSTRUCTIONS - IMPORTANT NOTES

Safety during installation work

When carrying out installation work in locations where there is a risk of falling, take appropriate safety precautions, e.g. use of a working platform. Make sure that the vehicle roof is sufficiently strong and stable to carry out the installation work (risk of damage or collapsing of roof).

In case of doubt, contact a qualified specialist dealer or the manufacturer of your vehicle to find an appropriate installation location.

Make sure that:

-The turntable and connected units are disconnected from the power supply

-The person carrying out the installation or repair does not suffer from vertigo and can move around safely on the roof of the caravan or motor home

-The person carrying out the installation or repair is wearing sturdy and non-slip shoes

-The person carrying out the installation or repair has a secure position to stand and hold on while working

-The roof and the climbing equipment used (e.g. ladder) are dry, clean and non-slip

-The roof can withstand the weight of the person carrying out the repairs

Attention! Risk of death or injury due to falling or the roof collapsing!

-Nobody should be inside the caravan/motor home underneath the antenna during dismantling/ installation

Attention! Risk of death or injury due to possible roof collapsing and falling parts!

Proper installation and safety

Essential information

A crucial safety factor is proper performance of installation and electrical connection work, and the specified alignment of the turntable in the direction of travel (park position), see also installation and connection.

Comply as precisely as possible with the installation conditions and steps described.

Modifications to the electrical installations in the vehicle should only be carried out by a specialist in vehicle electrics. Do not make any unauthorised changes to the turntable.

Adhesive sealant

The turntable is attached to the roof of the vehicle by adhesive and is secured by additional screws.

Note that the curing of the adhesive sealant is temperature-dependent. It reaches its full strength only after approximately five days.

During installation work, comply strictly with the processing and safety instructions for the adhesive sealant (Sikaflex® 291 safety data sheet and Sikaflex® 291 technical data sheet).

6

Image 6
Contents CAP Contents Foreign Language Installation MANUALS/DISPOSAL Disposal InstructionsSpent batteries are special waste Mobiset 3 CAP 700 COMPONENTS/SCOPE of Delivery Product PackageProper USE Proper USE USE for the Intended PurposeSafety Instructions Important Notes Essential informationAdhesive sealant Power supply, fusing Road Traffic Licensing Regulations StVZOChecks before commencing a journey Required Tools and Equipment Installation and ConnectionSelecting the Installation Location Unpacking and PreparationDirection of travel Installation Steps Ring AdhesiveArrow in the direction of travel Recess for cable Adhesive areas between the two grooves Installation of Turntable Direction of travel Version with External Cable Gland FIG. F Brief Instructions for Installing the Turntable Tightening torque 6 Nm Suspended Installation Installation on a Fixed Flat Surface They must not be reversed or the unit will not function Installation and Connection Connection Example for 12 V Battery Connection Reception RANGE/FOOTPRINT ESC Address of the Service CentreDismantling for Servicing DismantlingPolarisation Setting Polarisation SettingAstra Eutelsat Safety Notes Setting OperationsView after installation +45 Manual Lowering to Park Position Manual Lowering Technical Data Dimensions MMTechnical Data Type CAP Composition/data on components Sikaflex 291 Safety Data SheetMaterials/preparation and company designation Potential hazardsHandling and storage Measures for fire fightingMeasures if inadvertently released Exposure limitation and personal protective equipmentPhysical and chemical characteristics Stability and reactivityDisposal instructions Toxicology data SensitisationEcological data Transport dataOther data Sikaflex 291 Technical Data Sheet Sikaflex-291 IkaflexChemical Stability CAP 700 Operating Manual Important Information for CAP 700 Before Setup Remote ControlFirst Installation Page TV Scart Output TV aspect ratioPicture format SystemLocal time offset Alignment Satellite Search Moving the Antenna Manually Channel Satellite Selection Channel Selection from the Channel ListChange of LOCATION/TIMER Programming Timer ProgrammingMoving towards RESET/PARKING Resetting the Turn Table AntennaParking the Turntable Special Messages from the Turntable System Protection MessagesSpecial Messages from the Turntable Messages Arising from Software Problems Further Messages Declaration of Conformity For Your Notes 936.3417/-/0908/ZWT Technical data subject to change
Related manuals
Manual 1 pages 14.04 Kb