Siemens 4110 operating instructions System settings, Changing the names for internal subscribers

System settings

Step

by

step

System settings

The abbreviations in brackets after the titles stand for the corresponding ISDN feature. Some features can only be used if enabled by the provider (additional charge).

Changing the names for internal subscribers

With the factory default, the names Int.11, Int.12 etc. are allocated to all the in- ternal numbers in accordance with their numbering. These entries may be *changed to suit your requirements.

1.is pressed for menus.

2. Press [ ] and [OK ] to select: Base Settings → Settings → Setup user → Setup device → (required internal no. → [)] → Name.

3.Change the name and select [)] to confirm.

4.Press [Z] and [OK ] to select: Save entry.

The name is now displayed in the internal list and also when an internal call is made from this internal no.

Call waiting - activating/deactivating CW

This feature can be set up separately for each user. When call waiting is acti- vated, the caller hears the on-hook signal if you are already conducting a call.

If call waiting is deactivated, the caller hears the ring tone if you are already conducting a call and additional devices are assigned to this MSN.

If call waiting is deactivated, the caller hears the busy signal if you are already conducting a call, and are either the only user assigned this MSN, or if the fea- ture Busy signal when MSN is engaged (Busy on Busy) see page 32 has been activated.

1.Press *for selection menus.

2.Select using [Z] and [OK ]: Base Settings → Settings → Setup user → Setup device → (required internal user) → [)] → Call waiting

31