Operation using a telephone system
Step
by
Step
Activate the keypad for the next call only
All dialling characters
1.is pressed for menus.
2.Press [Z] and [OK ] to select: Base Settings → Call preparat. → Temp. keypad ('before menu item = ON / none = OFF).
Special requirements
If you encounter problems when connecting your Gigaset 4110/isdn behind your ISDN PBX, such as:
-handset does not ring to signal incoming calls, or
-a fault message is displayed
you should consider the following essential requirements:
First requirement:
Each Gigaset terminal (handset) requires a separate send MSN.
1st step
*Store 1 internal MSN of your PBX for each Gigaset terminal.
1.is pressed for menus.
2.Press [Z] and [OK ] to select: Base Settings → Settings → ISDN settings → Set up MSN .
2nd step
Assign each Gigaset terminal one of the previously stored MSNs as the send *MSN (such as “Internal 0” to “Internal 2”).
1.is pressed for menus.
2.Press [Z] and [OK ] to select: Base Settings → Settings → System settings → Setup user → Setup device → Press [)] to open the additional menu → Send MSN.
Second requirement:
It is not possible for several MSNs of the Gigaset to be called simultaneously from your PBX.
To ensure that the registered handsets can ring at the same time when a call arrives, first make the following setting:
3rd step
Store another internal MSN of your PBX in your Gigaset 4110isdn. This internal MSN of your PBX serves as a call group address for Gigaset terminals that can *be combined in step 2.
1.is pressed for menus.
2.Press [Z] and [OK ] to select: Base Settings → Settings → ISDN settings → Set up MSN .
84