HOW to USE the PULSE.DRIVEN Program

When the cool-down segment is completed, the
walking belt will slow to a stop. After the fitness
test program is com-
pleted, your fitness	level
will be shown in the		FL"LI.,1
Time display. There are		FL"LI.,1
Time display. There are
ten fitness levels--	t	_ SEGMENT TIME _	1

fitness level 10 (FL:10)	TIME
fitness level 10 (FL:10)
is the highest. Remem-

ber, the fitness program is intended only to indicate your relative fitness level.

Note: The Speed and Incline buttons will not function while the fitness test program is selected. If your pulse is not detected during the program, the letters "PLS" will flash in the Heart Rate/Calories display. If your pulse is not detected during the last thirty seconds of any 4-minute segment (after 4 minutes, after 8 minutes, etc.), the fitness test pro- gram will end and the Time display will show a fit- ness level of 0 (FL: 0).

The fitness test program cannot be stopped tem- porarily and then restarted. However, the program can be stopped at any time by pressing the Stop button. The Time display will then show an esti- mated fitness level.

D When the program has ended, remove the key.

Step onto the foot rails and make sure that the in- cline of the treadmill is at 1%. The incline must be at 1% when the treadmill is raised to the storage position. Next, remove the key from the console and put it in a secure place. Note: If the displays and indicators on the console remain lit after the key is removed, the console is in

the "demo" mode. Refer to page 24 and turn off the demo mode.

When you are finished using the treadmill, move the on/off switch near the power cord to the off position and unplug the power cord.

The pulse-driven program automatically adjusts the speed and incline of the treadmill to keep your heart rate near a target level during your workout. Note: You

must wear the optional chest pulse sensor to use the pulse-driven program (see page 24).

CAUTION : ifyouhaveheartprob-

lems, or if you are over 60 years of age and have been inactive, do not use the pulse-driven program. If you are taking medication regularly, consult your physician to find whether the medication will affect your exercise heart rate.

Follow the steps below to use the pulse-driven program.

_lPut on the chest pulse sensor.

Refer to the instructions included with the chest pulse sensor to put on the chest pulse sensor.

BInsert the key fully into the console. See GETTING STARTED on page 10.

Select the pulse-driven program.

When the key is inserted,			Indicator
the manual mode will be

selected	and the Manual	r,_,_r_u,'O000000C
indicator	will light. To se-	,A_	_O000000
		,,R_	_00000@@@
lect the	pulse-driven pro-	_Nss,s	_OOO@@@@@
		P_s_,v N	_0@@@@@@¢
gram, press the Select
Program	button repeat-

edly until the Pulse Driven indicator lights. When the pulse-driven program is selected, the program display will show a simplified profile of the program.

B Enter your age.

When the pulse-driven program is selected, an age setting will flash in the Incline display and the letters "AGE" will ap- pear in the Time display.

You must enter your age to use the pulse-driven program. If you have already entered your age, go to step 5. tf you have not entered your age, press the Enter Age buttons to enter your age. Four sec- onds after the buttons are pressed, the age setting will disappear from the display. Your age will then be saved in memory.