NordicTrack NTTL11994 user manual Trouble-Shooting, Problem The power turns off during use

Page 26

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll- free at 1-888-825-2588, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 8.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length. Important: The treadmill is not compatible with GFCl-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

C.Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position.

C

Tripped

Reset

Positionon

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the

circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. Make sure that the on/off switch is in the on position.

e. If the treadmill still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and unplug the power cord. Carefully tip the treadmill down as shown in drawing a. Remove the Screws (39, 83) from the hood. Raise the Uprights (69) and carefully remove the hood.

69

b.Locate the Reed Switch (10) and the Magnet (7) on the left side of the Pulley (8). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8". If necessary, loosen the Screw

(80)and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, and run the treadmill for a few minutes to check for a correct speed reading.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Customer HOT Line QUESTIONS?Serial No New products, prizes Fitness tips, and much moreTable of Contents Important Precautions WhenusingiFIT.comCDsandvideos,an Right Side Before YOU BeginLeft Side Assembly Your own phillips screwdriver Wire cuttersInserttwoHandrailBolts78withHandrailWashers Not tighten the Bolts yetResult in an increased risk of electric shock Operation AdjustmentPerformant Lube TM Walking Belt Product is properly grounded, Do not modifyFeatures of the Console Use of an optional chest pulse sensor seeEnter your weight Plug in the power cordKlMove the on/off switch to the on position Attach the clip to the waistband of your clothesHOW to USE the Manual Mode Measure your heart rate, if desired HOW to USE Preset ProgramsFISelect one of the five preset programs Storage position or the treadmill will beEasure your heart rate, if desired When the program has ended, remove the keyFollow your progress with the displays Programs Desired speed and incline settingsSelect one of the custom Ress StartHOW to USE Custom Programs Select the fitness test program HOW to USE the Fitness Test ProgramPut on the chest pulse sensor Enter your ageHOW to USE the PULSE.DRIVEN Program LPut on the chest pulse sensorTing for the first HOW to Connect Your Portable CD Player HOW to Connect Your Portable StereoRCA HOW to Connect Your Home StereoHOW to Connect Your Computer L1Insert the key fully into the console HOW to Connect Your VCRHOW to USE IFIT,COM CD and Video Programs Ress the Play button on your CD player or VCRHen the program is completed, remove the key Ollow your progress with the LED track and the displays HOW Touse Programs Directly from OUR Internet Site Follow the on-line instructions to start the program Optional chest pulse sensor Call toll-free Information MODE/DEMO ModeOptional Chest Pulse Sensor 825-2588HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USETROUBLE-SHOOTING Problem The power turns off during useWalking belt is off-center PROBLEMThe walking belt slows when walked onProblem Solution Workout Guidelines Conditioning GuidelinesExercise Intensity Inner Thigh Stretch Hamstring StretchQuadriceps Stretch Part LISTmModel No. NTTL11994 R0101A Key No. Qty DescriptionManual \\ r Limited Warranty
Related manuals
Manual 33 pages 55.06 Kb
Top Page Image Contents