NordicTrack NTL12940 Problem The walking belt slows when walked on, Power Cord, Move the key

Page 28

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 9.

b. If the walking belt is overtightened, treadmill perfor-

 

mance may decrease and the walking belt may be-

 

come damaged. Remove the key and

UNPLUG THE

POWER CORD

. Using the allen wrench, turn both

rear roller adjustment bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep

the walking belt centered. Plug in the power cord, in- sert the key and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

3”–4”

Rear Roller Adjustment Bolts

c. If the walking belt still slows when walked on, please call our Customer Service Department, toll- free.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:

a. If the walking belt is off-center, remove the key and

UN-

 

PLUG THE POWER CORD

. If the walking belt has

 

shifted to the left,

use the allen wrench to turn the left

 

rear roller bolt clockwise 1/2 of a turn;

if the walking belt

 

has shifted to the right,

turn the left rear roller bolt coun-

 

terclockwise 1/2 of a turn. Be careful not to overtighten the

 

walking belt. Plug in the power cord, insert the key, and

 

 

run the treadmill for a few minutes. Repeat until the walk-

 

ing belt is centered.

 

 

a

b. If the walking belt slips when walked on, first remove the

key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn.

When the walking belt is correctly tightened, you should

be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key, and care- fully walk on the treadmill for a few minutes. Repeat until

the walking belt is properly tightened.

b

PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com

CDs and videos are played

SOLUTION:

a. With the key in the console, press one of the Incline buttons.

While the incline is changing, re-

 

move the key.

After a few seconds, re-insert the key. The treadmill will automatically rise to the

 

maximum incline level and then return to the minimum level. This will recalibrate the incline.

 

28

Image 28
Contents QUESTIONS? Customer HOT LineTable of Contents Important Precautions Use the treadmill only as describedSame circuit. Do not use an extension cord Treadmill is capable of high speedsNever insert or drop any object into any opening Before YOU Begin Using the treadmillRight Side Assembly Your own phillips screwdriver Wire cuttersBe careful not to pinch the wires Not tighten the Bolts yetMake sure that Tighten the four 4 1/2 BoltsTurn the receiver so the small cylinder is on TreadmillThey were removed HOW to Plug in the Power Cord Performant LubeSurge suppressor must be electrically rated This product must be grounded.If it should malfuncFeatures of the Console Pulse Sensor ClipFree FollowHOW to Turn on the Power HOW to USE the Manual ModeChange the incline of the treadmill as desired Follow your progress with the displaysDisplay Training Zone DisplayHOW to USE Preset Programs Select one of the preset programsStand 7Turn on the fans if desiredAll Measure your heart rate if desiredTurn on the fans if desired KeyHOW to Create Custom Programs Select one of the custom programsPress the Start button or the Speed + button 7Whenkey. you are finished exercising, removeHOW to USE Custom Programs First segment endsWill Umn to the rightFollow the steps below to use a heart rate program 1Put on the optional chest pulse sensorInsert the key fully into the console Select a heart rate programEnter your age ProgramPress the Start button or the Speed + button to 7Follow your progress with the displaysHOW to Connect Your Portable Stereo HOW to Connect Your Portable CD PlayerVideocassettes HOW to Connect Your Home Stereo HOW to Connect Your ComputerPlug the adapter into the Line OUT jack on your stereo Audio 5mm Cable AdapterHOW to Connect Your VCR ProgramsWhen the CD or video program ends, the walking Console. HoweverStart button or the Speed ConsoleHOW to USE Programs Directly from OUR WEB Site Information MODE/DEMO Mode HOW to USE the Aromatherapy SystemHOW to Adjust the Cushioning System Optional Chest Pulse SensorHOW to Fold the Treadmill for Storage HOW to Move the TreadmillHOW to Lower the Treadmill for USE Hold the treadmill firmly with both hands, and lowerTroubleshooting SolutionProblem The walking belt slows when walked on Power CordIf the walking belt has Shifted to the leftConditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyQty Description Key No. Qty Ordering Replacement Parts Description Key No. QtyExploded R1003A What is COVERED-The entire NordicTrack Limited WarrantyPart No R1003A