Ironman Fitness LEGACY owner manual Console Harness Connection

Assembly

Assembly requires the included Allen wrench and Phillips screwdriver.

Do not plug in the power cord until all assembly steps are completed.

1.Leave the unit on the original packing material to assemble all parts.

2.Connect the console harness together. One side of harness is located near the motor cover on the bottom left side. The other end is located inside the Left Upright assembly. See Figure 1 and 2. Pull the wiring harness from top of upright tube making sure harness connectors are pulled into large hole at bottom of upright.

3.Install the Left and Right Uprights to the treadmill base frame by inserting the upright con- necting bracket into base frame as seen in Figure 1, using Allen Bolt 5/16”-18 x 70 (Qty. 2), Spring Washer 8 mm (Qty. 4), and Washer 9*16*1.6 mm (Qty. 4).

Next, install the Allen Bolt 5/16”-18 x 15 (Qty. 6), Spring Washer 8 mm (Qty. 6), and Washer 9*16*1.6 mm (Qty. 6). Refer to Figure 3.

Note: Do not tighten hardware in step 4 until step 7 is completed. Ensure that the Allen Bolt 5/16”-

18x 70 is placed in the upper hole on the upright and the Allen Bolt 5/16”-18 x 15 is placed on the lower whole of the upright.

RIGHT Upright
Left Upright
	SPRING WASHER 8 mm
WASHER 9*16*1.6MM
ALLEN BOLT 5/16” - 18x70	ALLEN BOLT
	5/16” - 18x15

Figure 1: Console Harness Location

Caution:

Make sure harness is installed inside the upright and pay attention not to pinch the wire harness.

Figure 2: Console Harness Connection