INTRODUCTION
ASSEMBLY STEP 4
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
HARDWARE BAG 4 CONTENTS :
UPQWJFX
SUPPORT BAR BOOT |
SUPPORT BARS |
MOUNTING BRACKET |
BOLT (E) |
(8 TOTAL) |
STEP C |
BRACKET |
SUPPORT BAR |
AOpen HARDWARE BAG 4.
BSlide SUPPORT BARS onto side MOUNTING BRACKETS and line up with top MOUNTING BRACKETS.
CInsert 2 BOLTS (E) into the tops and 2 BOLTS (E) into the bottoms of each SUPPORT BAR. The BRACKET should be on the outside of the SUPPORT BAR as shown in the drawing to the left.
DSlide SUPPORT BAR BOOTS down to cover Bolts (E).
CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE
ASSEMBLY STEP 5 |
|
| |
|
| Connect power plug to the treadmill | |
|
| and connect the cord to a power | |
|
| outlet. The on/off switch is located | |
|
| next to the power cord. Flip this | |
POWER SWITCH | CIRCUIT BREAKER | switch to the 'ON' position, so that | |
the switch is lit. You will hear a beep | |||
|
| ||
|
| and the console will light up. |
LIMITED WARRANTY
12
YOU’RE FINISHED!