Healthrider HTL93940 manual Assembly

ASSEMBLY

Assembly requires two persons. Place the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until the treadmill is assembled.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt, the sides of the walking platform, or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt or on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench_ and your own phillips screwdriver

1.With the help of a second person, carefully raise the Uprights (65) to a vertical position.

Have the second person hold the console assembly near the Uprights (65) as shown. Look under the console as- sembly and locate the Console Wire Harness (71).

Cut the plastic ties securing the Upright Wire Harness

(85)to the right Upright (65). Connect the Upright Wire Harness to the Console Wire Harness (71). Make sure to connect the connectors properly (see the inset draw- ing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

Console

Assembly\

2.Insert the Wire Harnesses (71,85) down into the right Upright (65).

Set the console assembly on the Uprights (65). While a second person holds the console assembly, attach the console assembly with four Console Bolts (133) and four

Console Washers (69) as shown. Firmly tighten the Console Bolts.

Console Assembly

85

_133

6